[wireless prism54] Fix frame length
prism54 is leaking information when passing transmits to the firmware.
There is no requirement to adjust the length to >= ETH_ZLEN.
Just pass the skb length (after possible adjustment).
Signed-off-by: Roger While <simrw@sim-basis.de>
Signed-off-by: Jeff Garzik <jgarzik@pobox.com>
diff --git a/drivers/net/wireless/prism54/islpci_eth.c b/drivers/net/wireless/prism54/islpci_eth.c
index 5952e99..0975dd4 100644
--- a/drivers/net/wireless/prism54/islpci_eth.c
+++ b/drivers/net/wireless/prism54/islpci_eth.c
@@ -97,12 +97,6 @@
/* lock the driver code */
spin_lock_irqsave(&priv->slock, flags);
- /* determine the amount of fragments needed to store the frame */
-
- frame_size = skb->len < ETH_ZLEN ? ETH_ZLEN : skb->len;
- if (init_wds)
- frame_size += 6;
-
/* check whether the destination queue has enough fragments for the frame */
curr_frag = le32_to_cpu(cb->driver_curr_frag[ISL38XX_CB_TX_DATA_LQ]);
if (unlikely(curr_frag - priv->free_data_tx >= ISL38XX_CB_TX_QSIZE)) {
@@ -213,6 +207,7 @@
/* store the skb address for future freeing */
priv->data_low_tx[index] = skb;
/* set the proper fragment start address and size information */
+ frame_size = skb->len;
fragment->size = cpu_to_le16(frame_size);
fragment->flags = cpu_to_le16(0); /* set to 1 if more fragments */
fragment->address = cpu_to_le32(pci_map_address);