wl1271: Enable/disable 11a support based on INI configuration
Instead of hardcoding 11a support, enable/disable driver support based on
the dual-mode-select parameter in the nvs-file general paramters.
Signed-off-by: Juuso Oikarinen <juuso.oikarinen@nokia.com>
Reviewed-by: Luciano Coelho <luciano.coelho@nokia.com>
Signed-off-by: Luciano Coelho <luciano.coelho@nokia.com>
diff --git a/drivers/net/wireless/wl12xx/wl1271_scan.c b/drivers/net/wireless/wl12xx/wl1271_scan.c
index 7f42ca9..8d30150 100644
--- a/drivers/net/wireless/wl12xx/wl1271_scan.c
+++ b/drivers/net/wireless/wl12xx/wl1271_scan.c
@@ -188,7 +188,7 @@
ret = wl1271_scan_send(wl, IEEE80211_BAND_2GHZ, true,
wl->conf.tx.basic_rate);
if (ret == WL1271_NOTHING_TO_SCAN) {
- if (wl1271_11a_enabled())
+ if (wl->enable_11a)
wl->scan.state = WL1271_SCAN_STATE_5GHZ_ACTIVE;
else
wl->scan.state = WL1271_SCAN_STATE_DONE;