cciss: do not use bit 2 doorbell reset
It causes NMIs which are undesirable at best, unsurvivable at worst.
Prefer the soft reset instead.
Signed-off-by: Stephen M. Cameron <scameron@beardog.cce.hp.com>
Signed-off-by: Jens Axboe <jaxboe@fusionio.com>
diff --git a/drivers/block/cciss.c b/drivers/block/cciss.c
index 865484e..9528e94 100644
--- a/drivers/block/cciss.c
+++ b/drivers/block/cciss.c
@@ -4673,8 +4673,14 @@
use_doorbell = DOORBELL_CTLR_RESET2;
} else {
use_doorbell = misc_fw_support & MISC_FW_DOORBELL_RESET;
- if (use_doorbell)
- use_doorbell = DOORBELL_CTLR_RESET;
+ if (use_doorbell) {
+ dev_warn(&pdev->dev, "Controller claims that "
+ "'Bit 2 doorbell reset' is "
+ "supported, but not 'bit 5 doorbell reset'. "
+ "Firmware update is recommended.\n");
+ rc = -ENOTSUPP; /* use the soft reset */
+ goto unmap_cfgtable;
+ }
}
rc = cciss_controller_hard_reset(pdev, vaddr, use_doorbell);