s2io: Formatting log message
S2IO driver is printing dev->name before the name being allocated, which
display eth%d instead of eth0, eth1, etc. Example:
eth%d: Enabling MSIX failed
eth%d: MSI-X requested but failed to enable
This patch just change eth%d to s2io.
Signed-off-by: Breno Leitao <leitao@linux.vnet.ibm.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/s2io.c b/drivers/net/s2io.c
index e0a353f..5cd2291 100644
--- a/drivers/net/s2io.c
+++ b/drivers/net/s2io.c
@@ -3862,7 +3862,7 @@
ret = pci_enable_msix(nic->pdev, nic->entries, nic->num_entries);
/* We fail init if error or we get less vectors than min required */
if (ret) {
- DBG_PRINT(ERR_DBG, "%s: Enabling MSIX failed\n", nic->dev->name);
+ DBG_PRINT(ERR_DBG, "s2io: Enabling MSI-X failed\n");
kfree(nic->entries);
nic->mac_control.stats_info->sw_stat.mem_freed
+= (nic->num_entries * sizeof(struct msix_entry));
@@ -8010,8 +8010,7 @@
if (ret) {
DBG_PRINT(ERR_DBG,
- "%s: MSI-X requested but failed to enable\n",
- dev->name);
+ "s2io: MSI-X requested but failed to enable\n");
sp->config.intr_type = INTA;
}
}