[PATCH] m68knommu: set irq priority/level different for each ColdFire serial port
Set the hardware interrupt priority to a different value for each
attached ColdFire serial port. According to the CPU documentation you
should not use the same combination of level/priority on more than one
device. People have reported odd serial port behavior with them set the
same.
Signed-off-by: Greg Ungerer <gerg@uclinux.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>
diff --git a/drivers/serial/mcfserial.c b/drivers/serial/mcfserial.c
index f2a51e6..d957a3a 100644
--- a/drivers/serial/mcfserial.c
+++ b/drivers/serial/mcfserial.c
@@ -1516,7 +1516,7 @@
icrp = (volatile unsigned char *) (MCF_MBAR + MCFICM_INTC0 +
MCFINTC_ICR0 + MCFINT_UART0 + info->line);
- *icrp = 0x33; /* UART0 with level 6, priority 3 */
+ *icrp = 0x30 + info->line; /* level 6, line based priority */
imrp = (volatile unsigned long *) (MCF_MBAR + MCFICM_INTC0 +
MCFINTC_IMRL);