usb: msm_otg: Allow support to use 2nd HSPHY with USB2 Core
Some platforms may have configuration to allow USB controller
work with any of the two HSPHYs present. By default driver
configures USB core to use primary HSPHY. Add support to allow
user select 2nd HSPHY using DT parameter.
Change-Id: I605aadf8109db385644a690fc945f482331bb347
Signed-off-by: Manu Gautam <mgautam@codeaurora.org>
diff --git a/Documentation/devicetree/bindings/usb/msm-hsusb.txt b/Documentation/devicetree/bindings/usb/msm-hsusb.txt
index efd33e7..6d06e99 100644
--- a/Documentation/devicetree/bindings/usb/msm-hsusb.txt
+++ b/Documentation/devicetree/bindings/usb/msm-hsusb.txt
@@ -69,6 +69,8 @@
- qcom,dp-manual-pullup: If present, vbus is not routed to USB controller/phy
and controller driver therefore enables pull-up explicitly before
starting controller using usbcmd run/stop bit.
+- qcom,usb2-enable-hsphy2: If present then USB2 controller is connected to 2nd
+ HSPHY.
Example HSUSB OTG controller device node :
usb@f9690000 {