| ADS Bitsy Single Board Computer |
| (It is different from Bitsy(iPAQ) of Compaq) |
| |
| For more details, contact Applied Data Systems or see |
| http://www.applieddata.net/products.html |
| |
| The Linux support for this product has been provided by |
| Woojung Huh <whuh@applieddata.net> |
| |
| Use 'make adsbitsy_config' before any 'make config'. |
| This will set up defaults for ADS Bitsy support. |
| |
| The kernel zImage is linked to be loaded and executed at 0xc0400000. |
| |
| Linux can be used with the ADS BootLoader that ships with the |
| newer rev boards. See their documentation on how to load Linux. |
| |
| Supported peripherals: |
| - SA1100 LCD frame buffer (8/16bpp...sort of) |
| - SA1111 USB Master |
| - SA1100 serial port |
| - pcmcia, compact flash |
| - touchscreen(ucb1200) |
| - console on LCD screen |
| - serial ports (ttyS[0-2]) |
| - ttyS0 is default for serial console |
| |
| To do: |
| - everything else! :-) |
| |
| Notes: |
| |
| - The flash on board is divided into 3 partitions. |
| You should be careful to use flash on board. |
| It's partition is different from GraphicsClient Plus and GraphicsMaster |
| |
| - 16bpp mode requires a different cable than what ships with the board. |
| Contact ADS or look through the manual to wire your own. Currently, |
| if you compile with 16bit mode support and switch into a lower bpp |
| mode, the timing is off so the image is corrupted. This will be |
| fixed soon. |
| |
| Any contribution can be sent to nico@fluxnic.net and will be greatly welcome! |