iwlwifi: send TXPOWER command after a new RXON command
The patch fixes the problem that TXPOWER command is not sent
after we issue a new RXON command which requires a tune. Otherwise
we won't be able to Tx any frames.
Signed-off-by: Zhu Yi <yi.zhu@intel.com>
Signed-off-by: John W. Linville <linville@tuxdriver.com>
diff --git a/drivers/net/wireless/iwlwifi/iwl4965-base.c b/drivers/net/wireless/iwlwifi/iwl4965-base.c
index 55648a8..71f5da3 100644
--- a/drivers/net/wireless/iwlwifi/iwl4965-base.c
+++ b/drivers/net/wireless/iwlwifi/iwl4965-base.c
@@ -328,16 +328,6 @@
if (!priv->error_recovering)
priv->start_calib = 0;
- iwl_init_sensitivity(priv);
-
- /* If we issue a new RXON command which required a tune then we must
- * send a new TXPOWER command or we won't be able to Tx any frames */
- ret = iwl_set_tx_power(priv, priv->tx_power_user_lmt, true);
- if (ret) {
- IWL_ERROR("Error sending TX power (%d)\n", ret);
- return ret;
- }
-
/* Add the broadcast address so we can send broadcast frames */
if (iwl_rxon_add_station(priv, iwl_bcast_addr, 0) ==
IWL_INVALID_STATION) {
@@ -373,6 +363,16 @@
memcpy(active_rxon, &priv->staging_rxon, sizeof(*active_rxon));
}
+ iwl_init_sensitivity(priv);
+
+ /* If we issue a new RXON command which required a tune then we must
+ * send a new TXPOWER command or we won't be able to Tx any frames */
+ ret = iwl_set_tx_power(priv, priv->tx_power_user_lmt, true);
+ if (ret) {
+ IWL_ERROR("Error sending TX power (%d)\n", ret);
+ return ret;
+ }
+
return 0;
}