mac80211: split off mesh handling entirely
This patch splits off mesh handling from the STA/IBSS.
Unfortunately it increases mesh code size a bit, but I
think it makes things clearer. The patch also reduces
per-interface run-time memory usage.
Also clean up a few places where ifdef is not required.
Signed-off-by: Johannes Berg <johannes@sipsolutions.net>
Signed-off-by: John W. Linville <linville@tuxdriver.com>
diff --git a/net/mac80211/rx.c b/net/mac80211/rx.c
index d080379..208563a 100644
--- a/net/mac80211/rx.c
+++ b/net/mac80211/rx.c
@@ -1404,7 +1404,7 @@
if (rx->flags & IEEE80211_RX_RA_MATCH) {
if (!mesh_hdr->ttl)
- IEEE80211_IFSTA_MESH_CTR_INC(&rx->sdata->u.sta,
+ IEEE80211_IFSTA_MESH_CTR_INC(&rx->sdata->u.mesh,
dropped_frames_ttl);
else {
struct ieee80211_hdr *fwd_hdr;
@@ -1591,9 +1591,11 @@
if (!(rx->flags & IEEE80211_RX_RA_MATCH))
return RX_DROP_MONITOR;
+ if (ieee80211_vif_is_mesh(&sdata->vif))
+ return ieee80211_mesh_rx_mgmt(sdata, rx->skb, rx->status);
+
if (sdata->vif.type != IEEE80211_IF_TYPE_STA &&
- sdata->vif.type != IEEE80211_IF_TYPE_IBSS &&
- sdata->vif.type != IEEE80211_IF_TYPE_MESH_POINT)
+ sdata->vif.type != IEEE80211_IF_TYPE_IBSS)
return RX_DROP_MONITOR;
if (sdata->flags & IEEE80211_SDATA_USERSPACE_MLME)