b43: LP-PHY: Implement spec updates and remove resolved FIXMEs
Larry has started re-checking all current routines against a new
version of the Broadcom MIPS driver. This patch implements the first
round of changes he documented on the specs wiki.
Also remove a few FIXMEs regarding missing initial values for variables
with dynamic initial values where reading the values has been implemented.
Signed-off-by: Gábor Stefanik <netrolller.3d@gmail.com>
Signed-off-by: John W. Linville <linville@tuxdriver.com>
diff --git a/drivers/net/wireless/b43/phy_lp.h b/drivers/net/wireless/b43/phy_lp.h
index 99cb038..e158d1f 100644
--- a/drivers/net/wireless/b43/phy_lp.h
+++ b/drivers/net/wireless/b43/phy_lp.h
@@ -825,11 +825,11 @@
enum b43_lpphy_txpctl_mode txpctl_mode;
/* Transmit isolation medium band */
- u8 tx_isolation_med_band; /* FIXME initial value? */
+ u8 tx_isolation_med_band;
/* Transmit isolation low band */
- u8 tx_isolation_low_band; /* FIXME initial value? */
+ u8 tx_isolation_low_band;
/* Transmit isolation high band */
- u8 tx_isolation_hi_band; /* FIXME initial value? */
+ u8 tx_isolation_hi_band;
/* Max transmit power medium band */
u16 max_tx_pwr_med_band;
@@ -848,7 +848,7 @@
s16 txpa[3], txpal[3], txpah[3];
/* Receive power offset */
- u8 rx_pwr_offset; /* FIXME initial value? */
+ u8 rx_pwr_offset;
/* TSSI transmit count */
u16 tssi_tx_count;
@@ -864,16 +864,16 @@
s8 tx_pwr_idx_over; /* FIXME initial value? */
/* RSSI vf */
- u8 rssi_vf; /* FIXME initial value? */
+ u8 rssi_vf;
/* RSSI vc */
- u8 rssi_vc; /* FIXME initial value? */
+ u8 rssi_vc;
/* RSSI gs */
- u8 rssi_gs; /* FIXME initial value? */
+ u8 rssi_gs;
/* RC cap */
u8 rc_cap; /* FIXME initial value? */
/* BX arch */
- u8 bx_arch; /* FIXME initial value? */
+ u8 bx_arch;
/* Full calibration channel */
u8 full_calib_chan; /* FIXME initial value? */
@@ -885,6 +885,8 @@
/* Used for "Save/Restore Dig Filt State" */
u16 dig_flt_state[9];
+ bool crs_usr_disable, crs_sys_disable;
+
unsigned int pdiv;
};