rt2x00: Fix QOS sequence counting
When IEEE80211_TX_CTL_ASSIGN_SEQ is not set,
the driver should disable hardware sequence counting
to make sure the mac80211 provided counter is used.
This fixes QOS sequence counting, since that is one
of the cases where mac80211 provides a seperate
sequence counter.
By moving the sequence counting code to rt2x00queue
we make sure that _all_ frames get the sequence counter,
including RTS/CTS and Beacon frames.
Signed-off-by: Ivo van Doorn <IvDoorn@gmail.com>
Signed-off-by: John W. Linville <linville@tuxdriver.com>
diff --git a/drivers/net/wireless/rt2x00/rt2x00queue.c b/drivers/net/wireless/rt2x00/rt2x00queue.c
index 7f44203..7b581a3 100644
--- a/drivers/net/wireless/rt2x00/rt2x00queue.c
+++ b/drivers/net/wireless/rt2x00/rt2x00queue.c
@@ -120,6 +120,7 @@
{
struct rt2x00_dev *rt2x00dev = entry->queue->rt2x00dev;
struct ieee80211_tx_info *tx_info = IEEE80211_SKB_CB(entry->skb);
+ struct rt2x00_intf *intf = vif_to_intf(tx_info->control.vif);
struct ieee80211_hdr *hdr = (struct ieee80211_hdr *)entry->skb->data;
struct ieee80211_rate *rate =
ieee80211_get_tx_rate(rt2x00dev->hw, tx_info);
@@ -200,6 +201,31 @@
}
/*
+ * Hardware should insert sequence counter.
+ * FIXME: We insert a software sequence counter first for
+ * hardware that doesn't support hardware sequence counting.
+ *
+ * This is wrong because beacons are not getting sequence
+ * numbers assigned properly.
+ *
+ * A secondary problem exists for drivers that cannot toggle
+ * sequence counting per-frame, since those will override the
+ * sequence counter given by mac80211.
+ */
+ if (tx_info->flags & IEEE80211_TX_CTL_ASSIGN_SEQ) {
+ spin_lock(&intf->lock);
+
+ if (test_bit(ENTRY_TXD_FIRST_FRAGMENT, &txdesc->flags))
+ intf->seqno += 0x10;
+ hdr->seq_ctrl &= cpu_to_le16(IEEE80211_SCTL_FRAG);
+ hdr->seq_ctrl |= cpu_to_le16(intf->seqno);
+
+ spin_unlock(&intf->lock);
+
+ __set_bit(ENTRY_TXD_GENERATE_SEQ, &txdesc->flags);
+ }
+
+ /*
* PLCP setup
* Length calculation depends on OFDM/CCK rate.
*/