ASoC: msm: Add I2S support for MDM9x15.
Add changes to enable I2S interface for MDM9x15.
Interface detection between slimbus and I2S is
done at codec init. Driver and functions for that
interface are called during routing. Proper amix
controls for the interface should be used.
Change-Id: I18a8ffab0d2fcdfebf460435eb81e8dacc38e25b
Signed-off-by: Venkat Sudhir <vsudhir@codeaurora.org>
diff --git a/arch/arm/mach-msm/board-9615.h b/arch/arm/mach-msm/board-9615.h
index 7dd003f..80656b3 100644
--- a/arch/arm/mach-msm/board-9615.h
+++ b/arch/arm/mach-msm/board-9615.h
@@ -1,4 +1,4 @@
-/* Copyright (c) 2011, Code Aurora Forum. All rights reserved.
+/* Copyright (c) 2011-2012, Code Aurora Forum. All rights reserved.
*
* This program is free software; you can redistribute it and/or modify
* it under the terms of the GNU General Public License version 2 and
@@ -17,6 +17,34 @@
#include <linux/mfd/pm8xxx/pm8018.h>
#include <linux/regulator/gpio-regulator.h>
+/*
+ * MDM9x15 I2S.
+ */
+#ifdef CONFIG_I2C
+#define I2C_SURF 1
+#define I2C_FFA (1 << 1)
+#define I2C_RUMI (1 << 2)
+#define I2C_SIM (1 << 3)
+#define I2C_FLUID (1 << 4)
+#define I2C_LIQUID (1 << 5)
+
+struct i2c_registry {
+ u8 machs;
+ int bus;
+ struct i2c_board_info *info;
+ int len;
+};
+#endif
+/* Tabla slave address for I2C */
+#define TABLA_I2C_SLAVE_ADDR 0x0d
+#define TABLA_ANALOG_I2C_SLAVE_ADDR 0x77
+#define TABLA_DIGITAL1_I2C_SLAVE_ADDR 0x66
+#define TABLA_DIGITAL2_I2C_SLAVE_ADDR 0x55
+#define MSM_9615_GSBI5_QUP_I2C_BUS_ID 0
+/*
+ * MDM9x15 I2S.
+ */
+
/* Macros assume PMIC GPIOs and MPPs start at 1 */
#define PM8018_GPIO_BASE NR_GPIO_IRQS
#define PM8018_GPIO_PM_TO_SYS(pm_gpio) (pm_gpio - 1 + PM8018_GPIO_BASE)
@@ -36,7 +64,7 @@
#define GPIO_VREG_ID_EXT_2P95V 0
extern struct gpio_regulator_platform_data msm_gpio_regulator_pdata[];
-
+uint32_t msm9615_rpm_get_swfi_latency(void);
int msm9615_init_gpiomux(void);
void msm9615_init_mmc(void);
void mdm9615_allocate_fb_region(void);