wl12xx: Do end-of-transactions transfers only if needed
On newer hardware revisions, there is no need to write the host's
counter at the end of a RX transaction. The same applies to writing the
number of packets at the end of a TX transaction.
It is generally a good idea to avoid unnecessary SDIO/SPI transfers.
Throughput and CPU usage are improved when avoiding these.
Send the host's RX counter and the TX packet count only if needed, based
on the hardware revision.
[Changed WL12XX_QUIRK_END_OF_TRANSACTION to use BIT(0) -- Luca]
Signed-off-by: Ido Yariv <ido@wizery.com>
Signed-off-by: Ohad Ben-Cohen <ohad@wizery.com>
Reviewed-by: Luciano Coelho <coelho@ti.com>
Signed-off-by: Luciano Coelho <coelho@ti.com>
diff --git a/drivers/net/wireless/wl12xx/boot.h b/drivers/net/wireless/wl12xx/boot.h
index d67dcff..17229b8 100644
--- a/drivers/net/wireless/wl12xx/boot.h
+++ b/drivers/net/wireless/wl12xx/boot.h
@@ -59,6 +59,11 @@
#define PG_VER_MASK 0x3c
#define PG_VER_OFFSET 2
+#define PG_MAJOR_VER_MASK 0x3
+#define PG_MAJOR_VER_OFFSET 0x0
+#define PG_MINOR_VER_MASK 0xc
+#define PG_MINOR_VER_OFFSET 0x2
+
#define CMD_MBOX_ADDRESS 0x407B4
#define POLARITY_LOW BIT(1)