[IA64] Add Variable Page Size and IA64 Support in Intel IOMMU
The patch contains Intel IOMMU IA64 specific code. It defines new
machvec dig_vtd, hooks for IOMMU, DMAR table detection, cache line flush
function, etc.
For a generic kernel with CONFIG_DMAR=y, if Intel IOMMU is detected,
dig_vtd is used for machinve vector. Otherwise, kernel falls back to
dig machine vector. Kernel parameter "machvec=dig" or "intel_iommu=off"
can be used to force kernel to boot dig machine vector.
Signed-off-by: Fenghua Yu <fenghua.yu@intel.com>
Signed-off-by: Tony Luck <tony.luck@intel.com>
diff --git a/arch/ia64/Kconfig b/arch/ia64/Kconfig
index 3b7aa38..a924a84 100644
--- a/arch/ia64/Kconfig
+++ b/arch/ia64/Kconfig
@@ -117,6 +117,7 @@
select NUMA
select ACPI_NUMA
select SWIOTLB
+ select PCI_MSI
help
This selects the system type of your hardware. A "generic" kernel
will run on any supported IA-64 system. However, if you configure
@@ -124,6 +125,7 @@
generic For any supported IA-64 system
DIG-compliant For DIG ("Developer's Interface Guide") compliant systems
+ DIG+Intel+IOMMU For DIG systems with Intel IOMMU
HP-zx1/sx1000 For HP systems
HP-zx1/sx1000+swiotlb For HP systems with (broken) DMA-constrained devices.
SGI-SN2 For SGI Altix systems
@@ -136,6 +138,11 @@
bool "DIG-compliant"
select SWIOTLB
+config IA64_DIG_VTD
+ bool "DIG+Intel+IOMMU"
+ select DMAR
+ select PCI_MSI
+
config IA64_HP_ZX1
bool "HP-zx1/sx1000"
help
@@ -581,6 +588,16 @@
source "drivers/pcmcia/Kconfig"
+config DMAR
+ bool "Support for DMA Remapping Devices (EXPERIMENTAL)"
+ depends on IA64_GENERIC && ACPI && EXPERIMENTAL
+ help
+ DMA remapping (DMAR) devices support enables independent address
+ translations for Direct Memory Access (DMA) from devices.
+ These DMA remapping devices are reported via ACPI tables
+ and include PCI device scope covered by these DMA
+ remapping devices.
+
endmenu
endif