Blackfin: bf537-stamp: add example ADXL346 orientation resources
Signed-off-by: Michael Hennerich <michael.hennerich@analog.com>
Signed-off-by: Mike Frysinger <vapier@gentoo.org>
diff --git a/arch/blackfin/mach-bf537/boards/stamp.c b/arch/blackfin/mach-bf537/boards/stamp.c
index 772b7ba..9eaf5b0 100644
--- a/arch/blackfin/mach-bf537/boards/stamp.c
+++ b/arch/blackfin/mach-bf537/boards/stamp.c
@@ -734,11 +734,11 @@
.y_plate_ohms = 486,
.pressure_max = 1000,
.pressure_min = 0,
- .stopacq_polarity = 1,
- .first_conversion_delay = 3,
- .acquisition_time = 1,
- .averaging = 1,
- .pen_down_acc_interval = 1,
+ .stopacq_polarity = 1,
+ .first_conversion_delay = 3,
+ .acquisition_time = 1,
+ .averaging = 1,
+ .pen_down_acc_interval = 1,
};
#endif
@@ -749,11 +749,11 @@
.x_plate_ohms = 620, /* 620 Ohm from the touch datasheet */
.pressure_max = 10000,
.pressure_min = 0,
- .first_conversion_delay = 3, /* wait 512us before do a first conversion */
- .acquisition_time = 1, /* 4us acquisition time per sample */
+ .first_conversion_delay = 3, /* wait 512us before do a first conversion */
+ .acquisition_time = 1, /* 4us acquisition time per sample */
.median = 2, /* do 8 measurements */
- .averaging = 1, /* take the average of 4 middle samples */
- .pen_down_acc_interval = 255, /* 9.4 ms */
+ .averaging = 1, /* take the average of 4 middle samples */
+ .pen_down_acc_interval = 255, /* 9.4 ms */
.gpio_export = 1, /* Export GPIO to gpiolib */
.gpio_base = -1, /* Dynamic allocation */
};
@@ -790,6 +790,11 @@
/* .ev_code_act_inactivity = KEY_A,*/ /* EV_KEY */
.power_mode = ADXL_AUTO_SLEEP | ADXL_LINK,
.fifo_mode = ADXL_FIFO_STREAM,
+ .orientation_enable = ADXL_EN_ORIENTATION_3D,
+ .deadzone_angle = ADXL_DEADZONE_ANGLE_10p8,
+ .divisor_length = ADXL_LP_FILTER_DIVISOR_16,
+ /* EV_KEY {+Z, +Y, +X, -X, -Y, -Z} */
+ .ev_codes_orient_3d = {BTN_Z, BTN_Y, BTN_X, BTN_A, BTN_B, BTN_C},
};
#endif