ath6kl: Allow enabling of P2P support
For now, use a module parameter (ath6kl_p2p) to allow P2P support
to be enabled. This is needed since there is no mechanism for
enabling the P2P mode more dynamically for a single netdev.
Signed-off-by: Jouni Malinen <jouni@qca.qualcomm.com>
Signed-off-by: Kalle Valo <kvalo@qca.qualcomm.com>
diff --git a/drivers/net/wireless/ath/ath6kl/init.c b/drivers/net/wireless/ath/ath6kl/init.c
index 3d67025..eca34aa 100644
--- a/drivers/net/wireless/ath/ath6kl/init.c
+++ b/drivers/net/wireless/ath/ath6kl/init.c
@@ -448,13 +448,26 @@
status = -EIO;
}
- ret = ath6kl_wmi_info_req_cmd(ar->wmi, P2P_FLAG_CAPABILITIES_REQ |
- P2P_FLAG_MACADDR_REQ |
- P2P_FLAG_HMODEL_REQ);
- if (ret) {
- ath6kl_dbg(ATH6KL_DBG_TRC, "failed to request P2P "
- "capabilities (%d) - assuming P2P not supported\n",
- ret);
+ if (ar->p2p) {
+ ret = ath6kl_wmi_info_req_cmd(ar->wmi,
+ P2P_FLAG_CAPABILITIES_REQ |
+ P2P_FLAG_MACADDR_REQ |
+ P2P_FLAG_HMODEL_REQ);
+ if (ret) {
+ ath6kl_dbg(ATH6KL_DBG_TRC, "failed to request P2P "
+ "capabilities (%d) - assuming P2P not "
+ "supported\n", ret);
+ ar->p2p = 0;
+ }
+ }
+
+ if (ar->p2p) {
+ /* Enable Probe Request reporting for P2P */
+ ret = ath6kl_wmi_probe_report_req_cmd(ar->wmi, true);
+ if (ret) {
+ ath6kl_dbg(ATH6KL_DBG_TRC, "failed to enable Probe "
+ "Request reporting (%d)\n", ret);
+ }
}
return status;
@@ -492,6 +505,10 @@
param |= (1 << HI_OPTION_NUM_DEV_SHIFT);
param |= (fw_iftype << HI_OPTION_FW_MODE_SHIFT);
+ if (ar->p2p && fw_iftype == HI_OPTION_FW_MODE_BSS_STA) {
+ param |= HI_OPTION_FW_SUBMODE_P2PDEV <<
+ HI_OPTION_FW_SUBMODE_SHIFT;
+ }
param |= (0 << HI_OPTION_MAC_ADDR_METHOD_SHIFT);
param |= (0 << HI_OPTION_FW_BRIDGE_SHIFT);