spi/bfin_spi: only request GPIO on first load
The gpiolib code does not allow people to do gpio_request() on a GPIO
once it has already been requested. So make sure we only request the
pin on the first setup of a SPI device. Otherwise, if you attempts to
reconfigure a SPI device on the fly (like change bit sizes), the setup
function incorrectly fails.
Signed-off-by: Michael Hennerich <michael.hennerich@analog.com>
Signed-off-by: Mike Frysinger <vapier@gentoo.org>
Signed-off-by: Grant Likely <grant.likely@secretlab.ca>
diff --git a/drivers/spi/spi_bfin5xx.c b/drivers/spi/spi_bfin5xx.c
index d3da41d..3f22351 100644
--- a/drivers/spi/spi_bfin5xx.c
+++ b/drivers/spi/spi_bfin5xx.c
@@ -1108,12 +1108,15 @@
}
if (chip->chip_select_num >= MAX_CTRL_CS) {
- ret = gpio_request(chip->cs_gpio, spi->modalias);
- if (ret) {
- dev_err(&spi->dev, "gpio_request() error\n");
- goto pin_error;
+ /* Only request on first setup */
+ if (spi_get_ctldata(spi) == NULL) {
+ ret = gpio_request(chip->cs_gpio, spi->modalias);
+ if (ret) {
+ dev_err(&spi->dev, "gpio_request() error\n");
+ goto pin_error;
+ }
+ gpio_direction_output(chip->cs_gpio, 1);
}
- gpio_direction_output(chip->cs_gpio, 1);
}
dev_dbg(&spi->dev, "setup spi chip %s, width is %d, dma is %d\n",