| /* |
| * Generic IEEE 1394 definitions |
| */ |
| |
| #ifndef _IEEE1394_IEEE1394_H |
| #define _IEEE1394_IEEE1394_H |
| |
| #define TCODE_WRITEQ 0x0 |
| #define TCODE_WRITEB 0x1 |
| #define TCODE_WRITE_RESPONSE 0x2 |
| #define TCODE_READQ 0x4 |
| #define TCODE_READB 0x5 |
| #define TCODE_READQ_RESPONSE 0x6 |
| #define TCODE_READB_RESPONSE 0x7 |
| #define TCODE_CYCLE_START 0x8 |
| #define TCODE_LOCK_REQUEST 0x9 |
| #define TCODE_ISO_DATA 0xa |
| #define TCODE_STREAM_DATA 0xa |
| #define TCODE_LOCK_RESPONSE 0xb |
| |
| #define RCODE_COMPLETE 0x0 |
| #define RCODE_CONFLICT_ERROR 0x4 |
| #define RCODE_DATA_ERROR 0x5 |
| #define RCODE_TYPE_ERROR 0x6 |
| #define RCODE_ADDRESS_ERROR 0x7 |
| |
| #define EXTCODE_MASK_SWAP 0x1 |
| #define EXTCODE_COMPARE_SWAP 0x2 |
| #define EXTCODE_FETCH_ADD 0x3 |
| #define EXTCODE_LITTLE_ADD 0x4 |
| #define EXTCODE_BOUNDED_ADD 0x5 |
| #define EXTCODE_WRAP_ADD 0x6 |
| |
| #define ACK_COMPLETE 0x1 |
| #define ACK_PENDING 0x2 |
| #define ACK_BUSY_X 0x4 |
| #define ACK_BUSY_A 0x5 |
| #define ACK_BUSY_B 0x6 |
| #define ACK_TARDY 0xb |
| #define ACK_CONFLICT_ERROR 0xc |
| #define ACK_DATA_ERROR 0xd |
| #define ACK_TYPE_ERROR 0xe |
| #define ACK_ADDRESS_ERROR 0xf |
| |
| /* Non-standard "ACK codes" for internal use */ |
| #define ACKX_NONE (-1) |
| #define ACKX_SEND_ERROR (-2) |
| #define ACKX_ABORTED (-3) |
| #define ACKX_TIMEOUT (-4) |
| |
| |
| #define IEEE1394_SPEED_100 0x00 |
| #define IEEE1394_SPEED_200 0x01 |
| #define IEEE1394_SPEED_400 0x02 |
| #define IEEE1394_SPEED_800 0x03 |
| #define IEEE1394_SPEED_1600 0x04 |
| #define IEEE1394_SPEED_3200 0x05 |
| /* The current highest tested speed supported by the subsystem */ |
| #define IEEE1394_SPEED_MAX IEEE1394_SPEED_800 |
| |
| /* Maps speed values above to a string representation */ |
| extern const char *hpsb_speedto_str[]; |
| |
| |
| /* 1394a cable PHY packets */ |
| #define SELFID_PWRCL_NO_POWER 0x0 |
| #define SELFID_PWRCL_PROVIDE_15W 0x1 |
| #define SELFID_PWRCL_PROVIDE_30W 0x2 |
| #define SELFID_PWRCL_PROVIDE_45W 0x3 |
| #define SELFID_PWRCL_USE_1W 0x4 |
| #define SELFID_PWRCL_USE_3W 0x5 |
| #define SELFID_PWRCL_USE_6W 0x6 |
| #define SELFID_PWRCL_USE_10W 0x7 |
| |
| #define SELFID_PORT_CHILD 0x3 |
| #define SELFID_PORT_PARENT 0x2 |
| #define SELFID_PORT_NCONN 0x1 |
| #define SELFID_PORT_NONE 0x0 |
| |
| #define PHYPACKET_LINKON 0x40000000 |
| #define PHYPACKET_PHYCONFIG_R 0x00800000 |
| #define PHYPACKET_PHYCONFIG_T 0x00400000 |
| #define EXTPHYPACKET_TYPE_PING 0x00000000 |
| #define EXTPHYPACKET_TYPE_REMOTEACCESS_BASE 0x00040000 |
| #define EXTPHYPACKET_TYPE_REMOTEACCESS_PAGED 0x00140000 |
| #define EXTPHYPACKET_TYPE_REMOTEREPLY_BASE 0x000C0000 |
| #define EXTPHYPACKET_TYPE_REMOTEREPLY_PAGED 0x001C0000 |
| #define EXTPHYPACKET_TYPE_REMOTECOMMAND 0x00200000 |
| #define EXTPHYPACKET_TYPE_REMOTECONFIRMATION 0x00280000 |
| #define EXTPHYPACKET_TYPE_RESUME 0x003C0000 |
| |
| #define EXTPHYPACKET_TYPEMASK 0xC0FC0000 |
| |
| #define PHYPACKET_PORT_SHIFT 24 |
| #define PHYPACKET_GAPCOUNT_SHIFT 16 |
| |
| /* 1394a PHY register map bitmasks */ |
| #define PHY_00_PHYSICAL_ID 0xFC |
| #define PHY_00_R 0x02 /* Root */ |
| #define PHY_00_PS 0x01 /* Power Status*/ |
| #define PHY_01_RHB 0x80 /* Root Hold-Off */ |
| #define PHY_01_IBR 0x80 /* Initiate Bus Reset */ |
| #define PHY_01_GAP_COUNT 0x3F |
| #define PHY_02_EXTENDED 0xE0 /* 0x7 for 1394a-compliant PHY */ |
| #define PHY_02_TOTAL_PORTS 0x1F |
| #define PHY_03_MAX_SPEED 0xE0 |
| #define PHY_03_DELAY 0x0F |
| #define PHY_04_LCTRL 0x80 /* Link Active Report Control */ |
| #define PHY_04_CONTENDER 0x40 |
| #define PHY_04_JITTER 0x38 |
| #define PHY_04_PWR_CLASS 0x07 /* Power Class */ |
| #define PHY_05_WATCHDOG 0x80 |
| #define PHY_05_ISBR 0x40 /* Initiate Short Bus Reset */ |
| #define PHY_05_LOOP 0x20 /* Loop Detect */ |
| #define PHY_05_PWR_FAIL 0x10 /* Cable Power Failure Detect */ |
| #define PHY_05_TIMEOUT 0x08 /* Arbitration State Machine Timeout */ |
| #define PHY_05_PORT_EVENT 0x04 /* Port Event Detect */ |
| #define PHY_05_ENAB_ACCEL 0x02 /* Enable Arbitration Acceleration */ |
| #define PHY_05_ENAB_MULTI 0x01 /* Ena. Multispeed Packet Concatenation */ |
| |
| #include <asm/byteorder.h> |
| |
| #ifdef __BIG_ENDIAN_BITFIELD |
| |
| struct selfid { |
| u32 packet_identifier:2; /* always binary 10 */ |
| u32 phy_id:6; |
| /* byte */ |
| u32 extended:1; /* if true is struct ext_selfid */ |
| u32 link_active:1; |
| u32 gap_count:6; |
| /* byte */ |
| u32 speed:2; |
| u32 phy_delay:2; |
| u32 contender:1; |
| u32 power_class:3; |
| /* byte */ |
| u32 port0:2; |
| u32 port1:2; |
| u32 port2:2; |
| u32 initiated_reset:1; |
| u32 more_packets:1; |
| } __attribute__((packed)); |
| |
| struct ext_selfid { |
| u32 packet_identifier:2; /* always binary 10 */ |
| u32 phy_id:6; |
| /* byte */ |
| u32 extended:1; /* if false is struct selfid */ |
| u32 seq_nr:3; |
| u32 reserved:2; |
| u32 porta:2; |
| /* byte */ |
| u32 portb:2; |
| u32 portc:2; |
| u32 portd:2; |
| u32 porte:2; |
| /* byte */ |
| u32 portf:2; |
| u32 portg:2; |
| u32 porth:2; |
| u32 reserved2:1; |
| u32 more_packets:1; |
| } __attribute__((packed)); |
| |
| #elif defined __LITTLE_ENDIAN_BITFIELD /* __BIG_ENDIAN_BITFIELD */ |
| |
| /* |
| * Note: these mean to be bit fields of a big endian SelfID as seen on a little |
| * endian machine. Without swapping. |
| */ |
| |
| struct selfid { |
| u32 phy_id:6; |
| u32 packet_identifier:2; /* always binary 10 */ |
| /* byte */ |
| u32 gap_count:6; |
| u32 link_active:1; |
| u32 extended:1; /* if true is struct ext_selfid */ |
| /* byte */ |
| u32 power_class:3; |
| u32 contender:1; |
| u32 phy_delay:2; |
| u32 speed:2; |
| /* byte */ |
| u32 more_packets:1; |
| u32 initiated_reset:1; |
| u32 port2:2; |
| u32 port1:2; |
| u32 port0:2; |
| } __attribute__((packed)); |
| |
| struct ext_selfid { |
| u32 phy_id:6; |
| u32 packet_identifier:2; /* always binary 10 */ |
| /* byte */ |
| u32 porta:2; |
| u32 reserved:2; |
| u32 seq_nr:3; |
| u32 extended:1; /* if false is struct selfid */ |
| /* byte */ |
| u32 porte:2; |
| u32 portd:2; |
| u32 portc:2; |
| u32 portb:2; |
| /* byte */ |
| u32 more_packets:1; |
| u32 reserved2:1; |
| u32 porth:2; |
| u32 portg:2; |
| u32 portf:2; |
| } __attribute__((packed)); |
| |
| #else |
| #error What? PDP endian? |
| #endif /* __BIG_ENDIAN_BITFIELD */ |
| |
| |
| #endif /* _IEEE1394_IEEE1394_H */ |