mach-netx/time.c: codingstyle cleanup
To prevent cluttering the next patches with noop noise, do the cleanup
in this separate patch:
- use tab to indent
- break comments before column 80
Signed-off-by: Uwe Kleine-König <u.kleine-koenig@pengutronix.de>
Acked-by: Sascha Hauer <s.hauer@pengutronix.de>
diff --git a/arch/arm/mach-netx/time.c b/arch/arm/mach-netx/time.c
index 7c540c1..be833bd 100644
--- a/arch/arm/mach-netx/time.c
+++ b/arch/arm/mach-netx/time.c
@@ -42,9 +42,9 @@
}
static struct irqaction netx_timer_irq = {
- .name = "NetX Timer Tick",
- .flags = IRQF_DISABLED | IRQF_TIMER | IRQF_IRQPOLL,
- .handler = netx_timer_interrupt,
+ .name = "NetX Timer Tick",
+ .flags = IRQF_DISABLED | IRQF_TIMER | IRQF_IRQPOLL,
+ .handler = netx_timer_interrupt,
};
cycle_t netx_get_cycles(void)
@@ -53,11 +53,11 @@
}
static struct clocksource clocksource_netx = {
- .name = "netx_timer",
+ .name = "netx_timer",
.rating = 200,
.read = netx_get_cycles,
.mask = CLOCKSOURCE_MASK(32),
- .shift = 20,
+ .shift = 20,
.flags = CLOCK_SOURCE_IS_CONTINUOUS,
};
@@ -77,20 +77,22 @@
/* acknowledge interrupt */
writel(COUNTER_BIT(0), NETX_GPIO_IRQ);
- /* Enable the interrupt in the specific timer register and start timer */
+ /* Enable the interrupt in the specific timer
+ * register and start timer
+ */
writel(COUNTER_BIT(0), NETX_GPIO_IRQ_ENABLE);
writel(NETX_GPIO_COUNTER_CTRL_IRQ_EN | NETX_GPIO_COUNTER_CTRL_RUN,
- NETX_GPIO_COUNTER_CTRL(0));
+ NETX_GPIO_COUNTER_CTRL(0));
setup_irq(NETX_IRQ_TIMER0, &netx_timer_irq);
/* Setup timer one for clocksource */
- writel(0, NETX_GPIO_COUNTER_CTRL(1));
- writel(0, NETX_GPIO_COUNTER_CURRENT(1));
- writel(0xFFFFFFFF, NETX_GPIO_COUNTER_MAX(1));
+ writel(0, NETX_GPIO_COUNTER_CTRL(1));
+ writel(0, NETX_GPIO_COUNTER_CURRENT(1));
+ writel(0xffffffff, NETX_GPIO_COUNTER_MAX(1));
- writel(NETX_GPIO_COUNTER_CTRL_RUN,
- NETX_GPIO_COUNTER_CTRL(1));
+ writel(NETX_GPIO_COUNTER_CTRL_RUN,
+ NETX_GPIO_COUNTER_CTRL(1));
clocksource_netx.mult =
clocksource_hz2mult(CLOCK_TICK_RATE, clocksource_netx.shift);