[PATCH] USB: UHCI: Increase port-reset completion delay for HP controllers

This patch (as657) increases the port-reset completion delay in uhci-hcd
for HP's embedded controllers.  Unlike other UHCI controllers, the HP
chips can take as long as 250 us to carry out the processing associated
with finishing a port reset.

This fixes Novell bug #148761.

Signed-off-by: Alan Stern <stern@rowland.harvard.edu>
Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>
diff --git a/drivers/usb/host/uhci-hub.c b/drivers/usb/host/uhci-hub.c
index a71e48a..152971d 100644
--- a/drivers/usb/host/uhci-hub.c
+++ b/drivers/usb/host/uhci-hub.c
@@ -99,6 +99,21 @@
 	}
 }
 
+/* Wait for the UHCI controller in HP's iLO2 server management chip.
+ * It can take up to 250 us to finish a reset and set the CSC bit.
+ */
+static void wait_for_HP(unsigned long port_addr)
+{
+	int i;
+
+	for (i = 10; i < 250; i += 10) {
+		if (inw(port_addr) & USBPORTSC_CSC)
+			return;
+		udelay(10);
+	}
+	/* Log a warning? */
+}
+
 static void uhci_check_ports(struct uhci_hcd *uhci)
 {
 	unsigned int port;
@@ -113,6 +128,12 @@
 				CLR_RH_PORTSTAT(USBPORTSC_PR);
 				udelay(10);
 
+				/* HP's server management chip requires
+				 * a longer delay. */
+				if (to_pci_dev(uhci_dev(uhci))->vendor ==
+						PCI_VENDOR_ID_HP)
+					wait_for_HP(port_addr);
+
 				/* If the port was enabled before, turning
 				 * reset on caused a port enable change.
 				 * Turning reset off causes a port connect