Blackfin SPI Driver: use the properl BIT_CTL_xxx defines
use the properl BIT_CTL_... defines rather than the internal driv er
CFG_SPI_... defines
Signed-off-by: Mike Frysinger <vapier.adi@gmail.com>
Signed-off-by: Bryan Wu <cooloney@kernel.org>
Cc: David Brownell <david-b@pacbell.net>
Signed-off-by: Andrew Morton <akpm@linux-foundation.org>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
diff --git a/drivers/spi/spi_bfin5xx.c b/drivers/spi/spi_bfin5xx.c
index 5ebb67b..1c10efb 100644
--- a/drivers/spi/spi_bfin5xx.c
+++ b/drivers/spi/spi_bfin5xx.c
@@ -799,7 +799,7 @@
/* start SPI transfer */
write_CTRL(drv_data,
- (cr | CFG_SPI_DMAWRITE | BIT_CTL_ENABLE));
+ (cr | BIT_CTL_TIMOD_DMA_TX | BIT_CTL_ENABLE));
/* just return here, there can only be one transfer
* in this mode
@@ -827,7 +827,7 @@
dma_config |= WNR;
dma_start_addr = (unsigned long)drv_data->rx;
- cr |= CFG_SPI_DMAREAD;
+ cr |= BIT_CTL_TIMOD_DMA_RX | BIT_CTL_SENDOPT;
} else if (drv_data->tx != NULL) {
dev_dbg(&drv_data->pdev->dev, "doing DMA out.\n");
@@ -839,7 +839,7 @@
drv_data->len_in_bytes));
dma_start_addr = (unsigned long)drv_data->tx;
- cr |= CFG_SPI_DMAWRITE;
+ cr |= BIT_CTL_TIMOD_DMA_TX;
} else
BUG();