pcmcia: remove memreq_t
Page already had to be set to 0; Offset can easily be passed as
parameter to pcmcia_map_mem_page.
CC: netdev@vger.kernel.org
CC: linux-wireless@vger.kernel.org
CC: linux-ide@vger.kernel.org
CC: linux-usb@vger.kernel.org
CC: laforge@gnumonks.org
CC: linux-mtd@lists.infradead.org
CC: linux-bluetooth@vger.kernel.org
CC: alsa-devel@alsa-project.org
CC: linux-serial@vger.kernel.org
CC: Michael Buesch <mb@bu3sch.de>
Signed-off-by: Dominik Brodowski <linux@dominikbrodowski.net>
diff --git a/drivers/net/pcmcia/xirc2ps_cs.c b/drivers/net/pcmcia/xirc2ps_cs.c
index 8fb0eb1..4eb6f98 100644
--- a/drivers/net/pcmcia/xirc2ps_cs.c
+++ b/drivers/net/pcmcia/xirc2ps_cs.c
@@ -870,7 +870,6 @@
if (local->dingo) {
win_req_t req;
- memreq_t mem;
/* Reset the modem's BAR to the correct value
* This is necessary because in the RequestConfiguration call,
@@ -898,9 +897,7 @@
goto config_error;
local->dingo_ccr = ioremap(req.Base,0x1000) + 0x0800;
- mem.CardOffset = 0x0;
- mem.Page = 0;
- if ((err = pcmcia_map_mem_page(link, link->win, &mem)))
+ if ((err = pcmcia_map_mem_page(link, link->win, 0)))
goto config_error;
/* Setup the CCRs; there are no infos in the CIS about the Ethernet