PCI hotplug: shpchp: message refinement
This patch refines messages in shpchp module. The main changes are as
follows:
- remove the trailing "."
- remove __func__ as much as possible
- capitalize the first letter of messages
- show PCI device address including its domain
Signed-off-by: Taku Izumi <izumi.taku@jp.fujitsu.com>
Signed-off-by: Jesse Barnes <jbarnes@virtuousgeek.org>
diff --git a/drivers/pci/hotplug/shpchp_pci.c b/drivers/pci/hotplug/shpchp_pci.c
index faecbfa..138f161 100644
--- a/drivers/pci/hotplug/shpchp_pci.c
+++ b/drivers/pci/hotplug/shpchp_pci.c
@@ -49,9 +49,7 @@
/* use default values if we can't get them from firmware */
if (get_hp_params_from_firmware(dev, &hpp) ||
!hpp.t0 || (hpp.t0->revision > 1)) {
- printk(KERN_WARNING
- "%s: Could not get hotplug parameters. Use defaults\n",
- __func__);
+ warn("Could not get hotplug parameters. Use defaults\n");
hpp.t0 = &hpp.type0_data;
hpp.t0->revision = 0;
hpp.t0->cache_line_size = 8;
@@ -105,9 +103,9 @@
dev = pci_get_slot(parent, PCI_DEVFN(p_slot->device, 0));
if (dev) {
- ctrl_err(ctrl,
- "Device %s already exists at %x:%x, cannot hot-add\n",
- pci_name(dev), p_slot->bus, p_slot->device);
+ ctrl_err(ctrl, "Device %s already exists "
+ "at %04x:%02x:%02x, cannot hot-add\n", pci_name(dev),
+ pci_domain_nr(parent), p_slot->bus, p_slot->device);
pci_dev_put(dev);
return -EINVAL;
}
@@ -173,8 +171,8 @@
struct pci_bus *parent = p_slot->ctrl->pci_dev->subordinate;
struct controller *ctrl = p_slot->ctrl;
- ctrl_dbg(ctrl, "%s: bus/dev = %x/%x\n",
- __func__, p_slot->bus, p_slot->device);
+ ctrl_dbg(ctrl, "%s: domain:bus:dev = %04x:%02x:%02x\n",
+ __func__, pci_domain_nr(parent), p_slot->bus, p_slot->device);
for (j=0; j<8 ; j++) {
struct pci_dev* temp = pci_get_slot(parent,