wl12xx: handle idle changes per-interface
Idle changes are currently handled per hardware.
However, some operations should be done only per-interface.
Signed-off-by: Eliad Peller <eliad@wizery.com>
Signed-off-by: Arik Nemtsov <arik@wizery.com>
Signed-off-by: Luciano Coelho <coelho@ti.com>
diff --git a/drivers/net/wireless/wl12xx/main.c b/drivers/net/wireless/wl12xx/main.c
index aa1c0f3..dbb088e 100644
--- a/drivers/net/wireless/wl12xx/main.c
+++ b/drivers/net/wireless/wl12xx/main.c
@@ -2540,13 +2540,6 @@
}
}
- if (changed & IEEE80211_CONF_CHANGE_IDLE && !is_ap) {
- ret = wl1271_sta_handle_idle(wl, wlvif,
- conf->flags & IEEE80211_CONF_IDLE);
- if (ret < 0)
- wl1271_warning("idle mode change failed %d", ret);
- }
-
/*
* if mac80211 changes the PSM mode, make sure the mode is not
* incorrectly changed after the pspoll failure active window.
@@ -3617,6 +3610,12 @@
do_join = true;
}
+ if (changed & BSS_CHANGED_IDLE) {
+ ret = wl1271_sta_handle_idle(wl, wlvif, bss_conf->idle);
+ if (ret < 0)
+ wl1271_warning("idle mode change failed %d", ret);
+ }
+
if ((changed & BSS_CHANGED_CQM)) {
bool enable = false;
if (bss_conf->cqm_rssi_thold)