serial: avoid stalling suspend if serial port won't drain
Some ports seem to be unable to drain their transmitters on shut down. Such a
problem can occur if the port is programmed for hardware imposed flow control,
characters are in the FIFO but the CTS signal is inactive.
Normally, this isn't a problem because most places where we wait for the
transmitter to drain have a time-out. However, there is no timeout in the
suspend path.
Give a port 30ms to drain; this is an arbitary value chosen to avoid long
delays if there are many such ports in the system, while giving a reasonable
chance for a single port to drain. Should a port not drain within this
timeout, issue a warning.
Signed-off-by: Russell King <rmk+kernel@arm.linux.org.uk>
Acked-by: Alan Cox <alan@lxorguk.ukuu.org.uk>
Signed-off-by: Andrew Morton <akpm@linux-foundation.org>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
diff --git a/drivers/serial/serial_core.c b/drivers/serial/serial_core.c
index 2554d2f..304fe32 100644
--- a/drivers/serial/serial_core.c
+++ b/drivers/serial/serial_core.c
@@ -1977,6 +1977,7 @@
if (state->info && state->info->flags & UIF_INITIALIZED) {
const struct uart_ops *ops = port->ops;
+ int tries;
state->info->flags = (state->info->flags & ~UIF_INITIALIZED)
| UIF_SUSPENDED;
@@ -1990,9 +1991,14 @@
/*
* Wait for the transmitter to empty.
*/
- while (!ops->tx_empty(port)) {
+ for (tries = 3; !ops->tx_empty(port) && tries; tries--) {
msleep(10);
}
+ if (!tries)
+ printk(KERN_ERR "%s%s%s%d: Unable to drain transmitter\n",
+ port->dev ? port->dev->bus_id : "",
+ port->dev ? ": " : "",
+ drv->dev_name, port->line);
ops->shutdown(port);
}