ata_piix: verify SIDPR access before enabling it
On certain configurations (certain macbooks), even though all the
conditions for SIDPR access described in the datasheet are met,
actually reading those registers just returns 0 and have no effect on
write. Verify SIDPR is actually working before enabling it.
This is reported by Ryan Roth in bz#10512.
Signed-off-by: Tejun Heo <htejun@gmail.com>
Cc: Ryan Roth <ryan.roth@ch2m.com>
Signed-off-by: Jeff Garzik <jgarzik@redhat.com>
diff --git a/drivers/ata/ata_piix.c b/drivers/ata/ata_piix.c
index ea2c764..a9027b8 100644
--- a/drivers/ata/ata_piix.c
+++ b/drivers/ata/ata_piix.c
@@ -1348,6 +1348,8 @@
{
struct pci_dev *pdev = to_pci_dev(host->dev);
struct piix_host_priv *hpriv = host->private_data;
+ struct ata_device *dev0 = &host->ports[0]->link.device[0];
+ u32 scontrol;
int i;
/* check for availability */
@@ -1366,6 +1368,29 @@
return;
hpriv->sidpr = pcim_iomap_table(pdev)[PIIX_SIDPR_BAR];
+
+ /* SCR access via SIDPR doesn't work on some configurations.
+ * Give it a test drive by inhibiting power save modes which
+ * we'll do anyway.
+ */
+ scontrol = piix_sidpr_read(dev0, SCR_CONTROL);
+
+ /* if IPM is already 3, SCR access is probably working. Don't
+ * un-inhibit power save modes as BIOS might have inhibited
+ * them for a reason.
+ */
+ if ((scontrol & 0xf00) != 0x300) {
+ scontrol |= 0x300;
+ piix_sidpr_write(dev0, SCR_CONTROL, scontrol);
+ scontrol = piix_sidpr_read(dev0, SCR_CONTROL);
+
+ if ((scontrol & 0xf00) != 0x300) {
+ dev_printk(KERN_INFO, host->dev, "SCR access via "
+ "SIDPR is available but doesn't work\n");
+ return;
+ }
+ }
+
host->ports[0]->ops = &piix_sidpr_sata_ops;
host->ports[1]->ops = &piix_sidpr_sata_ops;
}