tree 32192650a01c913a85953c0a756fca06320fef46
parent b8313b6da7e2e7c7f47d93d8561969a3ff9ba0ea
author Jonathan Brassow <jbrassow@redhat.com> 1252093232 +0100
committer Alasdair G Kergon <agk@redhat.com> 1252093232 +0100

dm raid1: do not allow log_failure variable to unset after being set

This patch fixes a bug which was triggering a case where the primary leg
could not be changed on failure even when the mirror was in-sync.

The case involves the failure of the primary device along with
the transient failure of the log device.  The problem is that
bios can be put on the 'failures' list (due to log failure)
before 'fail_mirror' is called due to the primary device failure.
Normally, this is fine, but if the log device failure is transient,
a subsequent iteration of the work thread, 'do_mirror', will
reset 'log_failure'.  The 'do_failures' function then resets
the 'in_sync' variable when processing bios on the failures list.
The 'in_sync' variable is what is used to determine if the
primary device can be switched in the event of a failure.  Since
this has been reset, the primary device is incorrectly assumed
to be not switchable.

The case has been seen in the cluster mirror context, where one
machine realizes the log device is dead before the other machines.
As the responsibilities of the server migrate from one node to
another (because the mirror is being reconfigured due to the failure),
the new server may think for a moment that the log device is fine -
thus resetting the 'log_failure' variable.

In any case, it is inappropiate for us to reset the 'log_failure'
variable.  The above bug simply illustrates that it can actually
hurt us.

Cc: stable@kernel.org
Signed-off-by: Jonathan Brassow <jbrassow@redhat.com>
Signed-off-by: Alasdair G Kergon <agk@redhat.com>