[PATCH] libata: convert several bmdma-style controllers to new EH, take #3
Convert sata_sis, svw, uli and vsc drivers to new EH. All the drivers
used to specify ATA_FLAG_SATA_RESET to tell libata to use SATA
hardreset instead of SRST. This patch makes all the converted drivers
use the standard bmdma error handler which uses both SRST and SATA
hardreset.
All the controllers should be able to perform SRST but still needs
verification. If some of the controllers can't do SRST, it will be
very easy to spot as it will show up during boot probing.
Signed-off-by: Tejun Heo <htejun@gmail.com>
Signed-off-by: Jeff Garzik <jeff@garzik.org>
diff --git a/drivers/scsi/sata_svw.c b/drivers/scsi/sata_svw.c
index d9b5168..c94b870 100644
--- a/drivers/scsi/sata_svw.c
+++ b/drivers/scsi/sata_svw.c
@@ -314,7 +314,6 @@
.check_status = k2_stat_check_status,
.exec_command = ata_exec_command,
.dev_select = ata_std_dev_select,
- .phy_reset = sata_phy_reset,
.bmdma_setup = k2_bmdma_setup_mmio,
.bmdma_start = k2_bmdma_start_mmio,
.bmdma_stop = ata_bmdma_stop,
@@ -322,7 +321,10 @@
.qc_prep = ata_qc_prep,
.qc_issue = ata_qc_issue_prot,
.data_xfer = ata_mmio_data_xfer,
- .eng_timeout = ata_eng_timeout,
+ .freeze = ata_bmdma_freeze,
+ .thaw = ata_bmdma_thaw,
+ .error_handler = ata_bmdma_error_handler,
+ .post_internal_cmd = ata_bmdma_post_internal_cmd,
.irq_handler = ata_interrupt,
.irq_clear = ata_bmdma_irq_clear,
.scr_read = k2_sata_scr_read,
@@ -422,8 +424,8 @@
writel(0x0, mmio_base + K2_SATA_SIM_OFFSET);
probe_ent->sht = &k2_sata_sht;
- probe_ent->host_flags = ATA_FLAG_SATA | ATA_FLAG_SATA_RESET |
- ATA_FLAG_NO_LEGACY | ATA_FLAG_MMIO;
+ probe_ent->host_flags = ATA_FLAG_SATA | ATA_FLAG_NO_LEGACY |
+ ATA_FLAG_MMIO;
probe_ent->port_ops = &k2_sata_ops;
probe_ent->n_ports = 4;
probe_ent->irq = pdev->irq;