[PATCH] IB/mthca: Use correct port width capability value
When we call the INIT_IB firmware command to bring up a port, use
the actual port width capability returned by the QUERY_DEV_LIM
command instead of always trying to enable both 1X and 4X. This
fixes breakage seen when the firmware is build to allow 4X only.
Signed-off-by: Roland Dreier <rolandd@cisco.com>
diff --git a/drivers/infiniband/hw/mthca/mthca_qp.c b/drivers/infiniband/hw/mthca/mthca_qp.c
index 8fbb4f1..b7e3d23 100644
--- a/drivers/infiniband/hw/mthca/mthca_qp.c
+++ b/drivers/infiniband/hw/mthca/mthca_qp.c
@@ -575,12 +575,11 @@
memset(¶m, 0, sizeof param);
- param.enable_1x = 1;
- param.enable_4x = 1;
- param.vl_cap = dev->limits.vl_cap;
- param.mtu_cap = dev->limits.mtu_cap;
- param.gid_cap = dev->limits.gid_table_len;
- param.pkey_cap = dev->limits.pkey_table_len;
+ param.port_width = dev->limits.port_width_cap;
+ param.vl_cap = dev->limits.vl_cap;
+ param.mtu_cap = dev->limits.mtu_cap;
+ param.gid_cap = dev->limits.gid_table_len;
+ param.pkey_cap = dev->limits.pkey_table_len;
err = mthca_INIT_IB(dev, ¶m, port, &status);
if (err)