spi: move more spi_setup() functionality into core
Move some common spi_setup() error checks into the SPI framework from the
spi_master controller drivers:
- Add a new "mode_bits" field to spi_master
- Use that in spi_setup to validate the spi->mode value being
requested. Setting this new field is now mandatory for any
controller supporting more than vanilla SPI_MODE_0.
- Update all spi_master drivers to:
* Initialize that field
* Remove current spi_setup() checks using that value.
This is a net minor code shrink.
Signed-off-by: David Brownell <dbrownell@users.sourceforge.net>
Signed-off-by: Andrew Morton <akpm@linux-foundation.org>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
diff --git a/drivers/spi/spi_imx.c b/drivers/spi/spi_imx.c
index 26d5ef0..c195e45 100644
--- a/drivers/spi/spi_imx.c
+++ b/drivers/spi/spi_imx.c
@@ -1171,9 +1171,6 @@
return -EINVAL;
}
-/* the spi->mode bits understood by this driver: */
-#define MODEBITS (SPI_CPOL | SPI_CPHA | SPI_CS_HIGH)
-
/* On first setup bad values must free chip_data memory since will cause
spi_new_device to fail. Bad value setup from protocol driver are simply not
applied and notified to the calling driver. */
@@ -1186,12 +1183,6 @@
u32 tmp;
int status = 0;
- if (spi->mode & ~MODEBITS) {
- dev_dbg(&spi->dev, "setup: unsupported mode bits %x\n",
- spi->mode & ~MODEBITS);
- return -EINVAL;
- }
-
/* Get controller data */
chip_info = spi->controller_data;
@@ -1478,6 +1469,9 @@
drv_data->master_info = platform_info;
drv_data->pdev = pdev;
+ /* the spi->mode bits understood by this driver: */
+ master->mode_bits = SPI_CPOL | SPI_CPHA | SPI_CS_HIGH;
+
master->bus_num = pdev->id;
master->num_chipselect = platform_info->num_chipselect;
master->dma_alignment = DMA_ALIGNMENT;