libertas: Extend MESH_CONFIG command to access non-volatile configuration
This patch is based on a patch from Shailendra Govardhan and Brian Cavagnolo.
It extends the MESH_CONFIG command to configure non-volatile parameters on
libertas devices that support them (e.g. OLPC Active Antenna).
This patch only implements the driver/firmware interface.
See http://dev.laptop.org/ticket/6823 for minimal testing results and known
issues.
Signed-off-by: Javier Cardona <javier@cozybit.com>
Signed-off-by: David Woodhouse <dwmw2@infradead.org>
Signed-off-by: John W. Linville <linville@tuxdriver.com>
diff --git a/drivers/net/wireless/libertas/defs.h b/drivers/net/wireless/libertas/defs.h
index d395201..3793cb9 100644
--- a/drivers/net/wireless/libertas/defs.h
+++ b/drivers/net/wireless/libertas/defs.h
@@ -170,6 +170,16 @@
#define MARVELL_MESH_IE_LENGTH 9
+/* Values used to populate the struct mrvl_mesh_ie. The only time you need this
+ * is when enabling the mesh using CMD_MESH_CONFIG.
+ */
+#define MARVELL_MESH_IE_TYPE 4
+#define MARVELL_MESH_IE_SUBTYPE 0
+#define MARVELL_MESH_IE_VERSION 0
+#define MARVELL_MESH_PROTO_ID_HWMP 0
+#define MARVELL_MESH_METRIC_ID 0
+#define MARVELL_MESH_CAPABILITY 0
+
/** INT status Bit Definition*/
#define MRVDRV_TX_DNLD_RDY 0x0001
#define MRVDRV_RX_UPLD_RDY 0x0002