[POWERPC] MPC5200 low power mode
Low-power mode implementation for Lite5200b.
Some I/O registers are also saved here.
A recent U-Boot that supports this (lite5200b_PM_config) is needed.
Signed-off-by: Domen Puncer <domen.puncer@telargo.com>
Signed-off-by: Sylvain Munaut <tnt@246tNt.com>
Signed-off-by: Paul Mackerras <paulus@samba.org>
diff --git a/arch/powerpc/platforms/52xx/lite5200.c b/arch/powerpc/platforms/52xx/lite5200.c
index ce3f695..e11d27f 100644
--- a/arch/powerpc/platforms/52xx/lite5200.c
+++ b/arch/powerpc/platforms/52xx/lite5200.c
@@ -85,7 +85,6 @@
}
#ifdef CONFIG_PM
-static u32 descr_a;
static void lite5200_suspend_prepare(void __iomem *mbar)
{
u8 pin = 1; /* GPIO_WKUP_1 (GPIO_PSC2_4) */
@@ -96,13 +95,18 @@
* power down usb port
* this needs to be called before of-ohci suspend code
*/
- descr_a = in_be32(mbar + 0x1048);
- out_be32(mbar + 0x1048, (descr_a & ~0x200) | 0x100);
+
+ /* set ports to "power switched" and "powered at the same time"
+ * USB Rh descriptor A: NPS = 0, PSM = 0 */
+ out_be32(mbar + 0x1048, in_be32(mbar + 0x1048) & ~0x300);
+ /* USB Rh status: LPS = 1 - turn off power */
+ out_be32(mbar + 0x1050, 0x00000001);
}
static void lite5200_resume_finish(void __iomem *mbar)
{
- out_be32(mbar + 0x1048, descr_a);
+ /* USB Rh status: LPSC = 1 - turn on power */
+ out_be32(mbar + 0x1050, 0x00010000);
}
#endif
@@ -122,7 +126,7 @@
#ifdef CONFIG_PM
mpc52xx_suspend.board_suspend_prepare = lite5200_suspend_prepare;
mpc52xx_suspend.board_resume_finish = lite5200_resume_finish;
- mpc52xx_pm_init();
+ lite5200_pm_init();
#endif
#ifdef CONFIG_PCI