iwlwifi: do not clear data after chain noise calib
Chain noise calibration data are cleared after the calibration is done
in iwlagn_gain_computation() and iwl4965_gain_computation(). This cause
the debugfs entries for those data useless. To provide valid debugging
info, clear those data right before starting the calibration instead.
Signed-off-by: Shanyu Zhao <shanyu.zhao@intel.com>
Signed-off-by: Reinette Chatre <reinette.chatre@intel.com>
diff --git a/drivers/net/wireless/iwlwifi/iwl-4965.c b/drivers/net/wireless/iwlwifi/iwl-4965.c
index 4e377c8..a0669ea 100644
--- a/drivers/net/wireless/iwlwifi/iwl-4965.c
+++ b/drivers/net/wireless/iwlwifi/iwl-4965.c
@@ -346,9 +346,19 @@
{
struct iwl_chain_noise_data *data = &(priv->chain_noise_data);
- if ((data->state == IWL_CHAIN_NOISE_ALIVE) && iwl_is_associated(priv)) {
+ if ((data->state == IWL_CHAIN_NOISE_ALIVE) &&
+ iwl_is_associated(priv)) {
struct iwl_calib_diff_gain_cmd cmd;
+ /* clear data for chain noise calibration algorithm */
+ data->chain_noise_a = 0;
+ data->chain_noise_b = 0;
+ data->chain_noise_c = 0;
+ data->chain_signal_a = 0;
+ data->chain_signal_b = 0;
+ data->chain_signal_c = 0;
+ data->beacon_count = 0;
+
memset(&cmd, 0, sizeof(cmd));
cmd.hdr.op_code = IWL_PHY_CALIBRATE_DIFF_GAIN_CMD;
cmd.diff_gain_a = 0;
@@ -419,13 +429,6 @@
/* Mark so we run this algo only once! */
data->state = IWL_CHAIN_NOISE_CALIBRATED;
}
- data->chain_noise_a = 0;
- data->chain_noise_b = 0;
- data->chain_noise_c = 0;
- data->chain_signal_a = 0;
- data->chain_signal_b = 0;
- data->chain_signal_c = 0;
- data->beacon_count = 0;
}
static void iwl4965_bg_txpower_work(struct work_struct *work)