diff --git a/drivers/net/ucc_geth.c b/drivers/net/ucc_geth.c
index 0cf22c4..255d28d 100644
--- a/drivers/net/ucc_geth.c
+++ b/drivers/net/ucc_geth.c
@@ -1,5 +1,5 @@
 /*
- * Copyright (C) 2006-2007 Freescale Semicondutor, Inc. All rights reserved.
+ * Copyright (C) 2006-2009 Freescale Semicondutor, Inc. All rights reserved.
  *
  * Author: Shlomi Gridish <gridish@freescale.com>
  *	   Li Yang <leoli@freescale.com>
@@ -1410,6 +1410,9 @@
 	    (ugeth->phy_interface == PHY_INTERFACE_MODE_RTBI)) {
 		upsmr |= UCC_GETH_UPSMR_TBIM;
 	}
+	if ((ugeth->phy_interface == PHY_INTERFACE_MODE_SGMII))
+		upsmr |= UCC_GETH_UPSMR_SGMM;
+
 	out_be32(&uf_regs->upsmr, upsmr);
 
 	/* Disable autonegotiation in tbi mode, because by default it
@@ -1531,6 +1534,49 @@
 	spin_unlock_irqrestore(&ugeth->lock, flags);
 }
 
+/* Initialize TBI PHY interface for communicating with the
+ * SERDES lynx PHY on the chip.  We communicate with this PHY
+ * through the MDIO bus on each controller, treating it as a
+ * "normal" PHY at the address found in the UTBIPA register.  We assume
+ * that the UTBIPA register is valid.  Either the MDIO bus code will set
+ * it to a value that doesn't conflict with other PHYs on the bus, or the
+ * value doesn't matter, as there are no other PHYs on the bus.
+ */
+static void uec_configure_serdes(struct net_device *dev)
+{
+	struct ucc_geth_private *ugeth = netdev_priv(dev);
+	struct ucc_geth_info *ug_info = ugeth->ug_info;
+	struct phy_device *tbiphy;
+
+	if (!ug_info->tbi_node) {
+		dev_warn(&dev->dev, "SGMII mode requires that the device "
+			"tree specify a tbi-handle\n");
+		return;
+	}
+
+	tbiphy = of_phy_find_device(ug_info->tbi_node);
+	if (!tbiphy) {
+		dev_err(&dev->dev, "error: Could not get TBI device\n");
+		return;
+	}
+
+	/*
+	 * If the link is already up, we must already be ok, and don't need to
+	 * configure and reset the TBI<->SerDes link.  Maybe U-Boot configured
+	 * everything for us?  Resetting it takes the link down and requires
+	 * several seconds for it to come back.
+	 */
+	if (phy_read(tbiphy, ENET_TBI_MII_SR) & TBISR_LSTATUS)
+		return;
+
+	/* Single clk mode, mii mode off(for serdes communication) */
+	phy_write(tbiphy, ENET_TBI_MII_ANA, TBIANA_SETTINGS);
+
+	phy_write(tbiphy, ENET_TBI_MII_TBICON, TBICON_CLK_SELECT);
+
+	phy_write(tbiphy, ENET_TBI_MII_CR, TBICR_SETTINGS);
+}
+
 /* Configure the PHY for dev.
  * returns 0 if success.  -1 if failure
  */
@@ -1554,6 +1600,9 @@
 		return -ENODEV;
 	}
 
+	if (priv->phy_interface == PHY_INTERFACE_MODE_SGMII)
+		uec_configure_serdes(dev);
+
 	phydev->supported &= (ADVERTISED_10baseT_Half |
 				 ADVERTISED_10baseT_Full |
 				 ADVERTISED_100baseT_Half |
@@ -3523,6 +3572,8 @@
 		return PHY_INTERFACE_MODE_RGMII_RXID;
 	if (strcasecmp(phy_connection_type, "rtbi") == 0)
 		return PHY_INTERFACE_MODE_RTBI;
+	if (strcasecmp(phy_connection_type, "sgmii") == 0)
+		return PHY_INTERFACE_MODE_SGMII;
 
 	return PHY_INTERFACE_MODE_MII;
 }
@@ -3567,6 +3618,7 @@
 		PHY_INTERFACE_MODE_RMII, PHY_INTERFACE_MODE_RGMII,
 		PHY_INTERFACE_MODE_GMII, PHY_INTERFACE_MODE_RGMII,
 		PHY_INTERFACE_MODE_TBI, PHY_INTERFACE_MODE_RTBI,
+		PHY_INTERFACE_MODE_SGMII,
 	};
 
 	ugeth_vdbg("%s: IN", __func__);
@@ -3658,6 +3710,9 @@
 	}
 	ug_info->phy_node = phy;
 
+	/* Find the TBI PHY node.  If it's not there, we don't support SGMII */
+	ug_info->tbi_node = of_parse_phandle(np, "tbi-handle", 0);
+
 	/* get the phy interface type, or default to MII */
 	prop = of_get_property(np, "phy-connection-type", NULL);
 	if (!prop) {
@@ -3682,6 +3737,7 @@
 		case PHY_INTERFACE_MODE_RGMII_TXID:
 		case PHY_INTERFACE_MODE_TBI:
 		case PHY_INTERFACE_MODE_RTBI:
+		case PHY_INTERFACE_MODE_SGMII:
 			max_speed = SPEED_1000;
 			break;
 		default:
diff --git a/drivers/net/ucc_geth.h b/drivers/net/ucc_geth.h
index dca628a..1525bf5 100644
--- a/drivers/net/ucc_geth.h
+++ b/drivers/net/ucc_geth.h
@@ -1,5 +1,5 @@
 /*
- * Copyright (C) Freescale Semicondutor, Inc. 2006. All rights reserved.
+ * Copyright (C) Freescale Semicondutor, Inc. 2006-2009. All rights reserved.
  *
  * Author: Shlomi Gridish <gridish@freescale.com>
  *
@@ -193,6 +193,31 @@
 #define	ENET_TBI_MII_JD		0x10	/* Jitter diagnostics */
 #define	ENET_TBI_MII_TBICON	0x11	/* TBI control */
 
+/* TBI MDIO register bit fields*/
+#define TBISR_LSTATUS          0x0004
+#define TBICON_CLK_SELECT       0x0020
+#define TBIANA_ASYMMETRIC_PAUSE 0x0100
+#define TBIANA_SYMMETRIC_PAUSE  0x0080
+#define TBIANA_HALF_DUPLEX      0x0040
+#define TBIANA_FULL_DUPLEX      0x0020
+#define TBICR_PHY_RESET         0x8000
+#define TBICR_ANEG_ENABLE       0x1000
+#define TBICR_RESTART_ANEG      0x0200
+#define TBICR_FULL_DUPLEX       0x0100
+#define TBICR_SPEED1_SET        0x0040
+
+#define TBIANA_SETTINGS ( \
+		TBIANA_ASYMMETRIC_PAUSE \
+		| TBIANA_SYMMETRIC_PAUSE \
+		| TBIANA_FULL_DUPLEX \
+		)
+#define TBICR_SETTINGS ( \
+		TBICR_PHY_RESET \
+		| TBICR_ANEG_ENABLE \
+		| TBICR_FULL_DUPLEX \
+		| TBICR_SPEED1_SET \
+		)
+
 /* UCC GETH MACCFG1 (MAC Configuration 1 Register) */
 #define MACCFG1_FLOW_RX                         0x00000020	/* Flow Control
 								   Rx */
@@ -1100,6 +1125,7 @@
 	u16 pausePeriod;
 	u16 extensionField;
 	struct device_node *phy_node;
+	struct device_node *tbi_node;
 	u8 weightfactor[NUM_TX_QUEUES];
 	u8 interruptcoalescingmaxvalue[NUM_RX_QUEUES];
 	u8 l2qt[UCC_GETH_VLAN_PRIORITY_MAX];