cfg80211: rework key operation
This reworks the key operation in cfg80211, and now only
allows, from userspace, configuring keys (via nl80211)
after the connection has been established (in managed
mode), the IBSS been joined (in IBSS mode), at any time
(in AP[_VLAN] modes) or never for all the other modes.
In order to do shared key authentication correctly, it
is now possible to give a WEP key to the AUTH command.
To configure static WEP keys, these are given to the
CONNECT or IBSS_JOIN command directly, for a userspace
SME it is assumed it will configure it properly after
the connection has been established.
Since mac80211 used to check the default key in IBSS
mode to see whether or not the network is protected,
it needs an update in that area, as well as an update
to make use of the WEP key passed to auth() for shared
key authentication.
Signed-off-by: Johannes Berg <johannes@sipsolutions.net>
Signed-off-by: John W. Linville <linville@tuxdriver.com>
diff --git a/net/wireless/core.c b/net/wireless/core.c
index 1a78b3c..97cc596 100644
--- a/net/wireless/core.c
+++ b/net/wireless/core.c
@@ -666,14 +666,10 @@
wdev_lock(wdev);
switch (wdev->iftype) {
case NL80211_IFTYPE_ADHOC:
- if (wdev->wext.ibss.ssid_len)
- __cfg80211_join_ibss(rdev, dev,
- &wdev->wext.ibss);
+ cfg80211_ibss_wext_join(rdev, wdev);
break;
case NL80211_IFTYPE_STATION:
- if (wdev->wext.connect.ssid_len)
- __cfg80211_connect(rdev, dev,
- &wdev->wext.connect);
+ cfg80211_mgd_wext_connect(rdev, wdev);
break;
default:
break;
@@ -690,6 +686,9 @@
}
mutex_unlock(&rdev->devlist_mtx);
mutex_destroy(&wdev->mtx);
+#ifdef CONFIG_WIRELESS_EXT
+ kfree(wdev->wext.keys);
+#endif
break;
case NETDEV_PRE_UP:
if (!(wdev->wiphy->interface_modes & BIT(wdev->iftype)))