| #ifndef __ASM_MACH_APIC_H |
| #define __ASM_MACH_APIC_H |
| |
| #define xapic_phys_to_log_apicid(cpu) (per_cpu(x86_bios_cpu_apicid, cpu)) |
| #define esr_disable (1) |
| |
| static inline int apic_id_registered(void) |
| { |
| return (1); |
| } |
| |
| /* Round robin the irqs amoung the online cpus */ |
| static inline cpumask_t target_cpus(void) |
| { |
| static unsigned long cpu = NR_CPUS; |
| do { |
| if (cpu >= NR_CPUS) |
| cpu = first_cpu(cpu_online_map); |
| else |
| cpu = next_cpu(cpu, cpu_online_map); |
| } while (cpu >= NR_CPUS); |
| return cpumask_of_cpu(cpu); |
| } |
| |
| #undef APIC_DEST_LOGICAL |
| #define APIC_DEST_LOGICAL 0 |
| #define TARGET_CPUS (target_cpus()) |
| #define APIC_DFR_VALUE (APIC_DFR_FLAT) |
| #define INT_DELIVERY_MODE (dest_Fixed) |
| #define INT_DEST_MODE (0) /* phys delivery to target proc */ |
| #define NO_BALANCE_IRQ (0) |
| #define WAKE_SECONDARY_VIA_INIT |
| |
| |
| static inline unsigned long check_apicid_used(physid_mask_t bitmap, int apicid) |
| { |
| return (0); |
| } |
| |
| static inline unsigned long check_apicid_present(int bit) |
| { |
| return (1); |
| } |
| |
| static inline unsigned long calculate_ldr(int cpu) |
| { |
| unsigned long val, id; |
| val = apic_read(APIC_LDR) & ~APIC_LDR_MASK; |
| id = xapic_phys_to_log_apicid(cpu); |
| val |= SET_APIC_LOGICAL_ID(id); |
| return val; |
| } |
| |
| /* |
| * Set up the logical destination ID. |
| * |
| * Intel recommends to set DFR, LDR and TPR before enabling |
| * an APIC. See e.g. "AP-388 82489DX User's Manual" (Intel |
| * document number 292116). So here it goes... |
| */ |
| static inline void init_apic_ldr(void) |
| { |
| unsigned long val; |
| int cpu = smp_processor_id(); |
| |
| apic_write(APIC_DFR, APIC_DFR_VALUE); |
| val = calculate_ldr(cpu); |
| apic_write(APIC_LDR, val); |
| } |
| |
| static inline void setup_apic_routing(void) |
| { |
| printk("Enabling APIC mode: %s. Using %d I/O APICs\n", |
| "Physflat", nr_ioapics); |
| } |
| |
| static inline int multi_timer_check(int apic, int irq) |
| { |
| return (0); |
| } |
| |
| static inline int apicid_to_node(int logical_apicid) |
| { |
| return apicid_2_node[hard_smp_processor_id()]; |
| } |
| |
| static inline int cpu_present_to_apicid(int mps_cpu) |
| { |
| if (mps_cpu < NR_CPUS) |
| return (int) per_cpu(x86_bios_cpu_apicid, mps_cpu); |
| |
| return BAD_APICID; |
| } |
| |
| static inline physid_mask_t apicid_to_cpu_present(int phys_apicid) |
| { |
| return physid_mask_of_physid(phys_apicid); |
| } |
| |
| extern u8 cpu_2_logical_apicid[]; |
| /* Mapping from cpu number to logical apicid */ |
| static inline int cpu_to_logical_apicid(int cpu) |
| { |
| if (cpu >= NR_CPUS) |
| return BAD_APICID; |
| return cpu_physical_id(cpu); |
| } |
| |
| static inline physid_mask_t ioapic_phys_id_map(physid_mask_t phys_map) |
| { |
| /* For clustered we don't have a good way to do this yet - hack */ |
| return physids_promote(0xFFL); |
| } |
| |
| static inline void setup_portio_remap(void) |
| { |
| } |
| |
| static inline void enable_apic_mode(void) |
| { |
| } |
| |
| static inline int check_phys_apicid_present(int boot_cpu_physical_apicid) |
| { |
| return (1); |
| } |
| |
| /* As we are using single CPU as destination, pick only one CPU here */ |
| static inline unsigned int cpu_mask_to_apicid(cpumask_t cpumask) |
| { |
| int cpu; |
| int apicid; |
| |
| cpu = first_cpu(cpumask); |
| apicid = cpu_to_logical_apicid(cpu); |
| return apicid; |
| } |
| |
| static inline u32 phys_pkg_id(u32 cpuid_apic, int index_msb) |
| { |
| return cpuid_apic >> index_msb; |
| } |
| |
| #endif /* __ASM_MACH_APIC_H */ |