| /* |
| * Copyright (C) 2014 The Android Open Source Project |
| * All rights reserved. |
| * |
| * Redistribution and use in source and binary forms, with or without |
| * modification, are permitted provided that the following conditions |
| * are met: |
| * * Redistributions of source code must retain the above copyright |
| * notice, this list of conditions and the following disclaimer. |
| * * Redistributions in binary form must reproduce the above copyright |
| * notice, this list of conditions and the following disclaimer in |
| * the documentation and/or other materials provided with the |
| * distribution. |
| * |
| * THIS SOFTWARE IS PROVIDED BY THE COPYRIGHT HOLDERS AND CONTRIBUTORS |
| * "AS IS" AND ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT |
| * LIMITED TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS |
| * FOR A PARTICULAR PURPOSE ARE DISCLAIMED. IN NO EVENT SHALL THE |
| * COPYRIGHT OWNER OR CONTRIBUTORS BE LIABLE FOR ANY DIRECT, INDIRECT, |
| * INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL DAMAGES (INCLUDING, |
| * BUT NOT LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS OR SERVICES; LOSS |
| * OF USE, DATA, OR PROFITS; OR BUSINESS INTERRUPTION) HOWEVER CAUSED |
| * AND ON ANY THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT LIABILITY, |
| * OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY OUT |
| * OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY OF |
| * SUCH DAMAGE. |
| */ |
| |
| /* |
| Copyright (c) 2014, Linaro Limited |
| All rights reserved. |
| |
| Redistribution and use in source and binary forms, with or without |
| modification, are permitted provided that the following conditions are met: |
| * Redistributions of source code must retain the above copyright |
| notice, this list of conditions and the following disclaimer. |
| * Redistributions in binary form must reproduce the above copyright |
| notice, this list of conditions and the following disclaimer in the |
| documentation and/or other materials provided with the distribution. |
| * Neither the name of the Linaro nor the |
| names of its contributors may be used to endorse or promote products |
| derived from this software without specific prior written permission. |
| |
| THIS SOFTWARE IS PROVIDED BY THE COPYRIGHT HOLDERS AND CONTRIBUTORS |
| "AS IS" AND ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT |
| LIMITED TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR |
| A PARTICULAR PURPOSE ARE DISCLAIMED. IN NO EVENT SHALL THE COPYRIGHT |
| HOLDER OR CONTRIBUTORS BE LIABLE FOR ANY DIRECT, INDIRECT, INCIDENTAL, |
| SPECIAL, EXEMPLARY, OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT |
| LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS OR SERVICES; LOSS OF USE, |
| DATA, OR PROFITS; OR BUSINESS INTERRUPTION) HOWEVER CAUSED AND ON ANY |
| THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT LIABILITY, OR TORT |
| (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY OUT OF THE USE |
| OF THIS SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY OF SUCH DAMAGE. |
| */ |
| |
| /* Assumptions: |
| * |
| * ARMv8-a, AArch64 |
| */ |
| |
| #if !defined(STPCPY) && !defined(STRCPY) |
| #error "Either STPCPY or STRCPY must be defined." |
| #endif |
| |
| #include <private/bionic_asm.h> |
| |
| /* Arguments and results. */ |
| #if defined(STPCPY) |
| #define dst x0 |
| #elif defined(STRCPY) |
| #define dstin x0 |
| #endif |
| #define src x1 |
| |
| /* Locals and temporaries. */ |
| #if defined(STRCPY) |
| #define dst x2 |
| #endif |
| #define data1 x3 |
| #define data1_w w3 |
| #define data2 x4 |
| #define data2_w w4 |
| #define has_nul1 x5 |
| #define has_nul1_w w5 |
| #define has_nul2 x6 |
| #define tmp1 x7 |
| #define tmp2 x8 |
| #define tmp3 x9 |
| #define tmp4 x10 |
| #define zeroones x11 |
| #define zeroones_w w11 |
| #define pos x12 |
| |
| #define REP8_01 0x0101010101010101 |
| #define REP8_7f 0x7f7f7f7f7f7f7f7f |
| #define REP8_80 0x8080808080808080 |
| |
| #if defined(STPCPY) |
| ENTRY(stpcpy) |
| #elif defined(STRCPY) |
| ENTRY(strcpy) |
| #endif |
| mov zeroones, #REP8_01 |
| #if defined(STRCPY) |
| mov dst, dstin |
| #endif |
| ands tmp1, src, #15 |
| b.ne .Lmisaligned |
| // NUL detection works on the principle that (X - 1) & (~X) & 0x80 |
| // (=> (X - 1) & ~(X | 0x7f)) is non-zero iff a byte is zero, and |
| // can be done in parallel across the entire word. |
| // The inner loop deals with two Dwords at a time. This has a |
| // slightly higher start-up cost, but we should win quite quickly, |
| // especially on cores with a high number of issue slots per |
| // cycle, as we get much better parallelism out of the operations. |
| .Lloop: |
| ldp data1, data2, [src], #16 |
| sub tmp1, data1, zeroones |
| orr tmp2, data1, #REP8_7f |
| bic has_nul1, tmp1, tmp2 |
| cbnz has_nul1, .Lnul_in_data1 |
| sub tmp3, data2, zeroones |
| orr tmp4, data2, #REP8_7f |
| bic has_nul2, tmp3, tmp4 |
| cbnz has_nul2, .Lnul_in_data2 |
| // No NUL in either register, copy it in a single instruction. |
| stp data1, data2, [dst], #16 |
| b .Lloop |
| |
| .Lnul_in_data1: |
| rev has_nul1, has_nul1 |
| clz pos, has_nul1 |
| add tmp1, pos, #0x8 |
| |
| tbz tmp1, #6, 1f |
| #if defined(STPCPY) |
| str data1, [dst], #7 |
| #elif defined(STRCPY) |
| str data1, [dst] |
| #endif |
| ret |
| 1: |
| tbz tmp1, #5, 1f |
| str data1_w, [dst], #4 |
| lsr data1, data1, #32 |
| 1: |
| tbz tmp1, #4, 1f |
| strh data1_w, [dst], #2 |
| lsr data1, data1, #16 |
| 1: |
| tbz tmp1, #3, 1f |
| strb data1_w, [dst] |
| #if defined(STPCPY) |
| ret |
| #endif |
| 1: |
| #if defined(STPCPY) |
| // Back up one so that dst points to the '\0' string terminator. |
| sub dst, dst, #1 |
| #endif |
| ret |
| |
| .Lnul_in_data2: |
| str data1, [dst], #8 |
| rev has_nul2, has_nul2 |
| clz pos, has_nul2 |
| add tmp1, pos, #0x8 |
| |
| tbz tmp1, #6, 1f |
| #if defined(STPCPY) |
| str data2, [dst], #7 |
| #elif defined(STRCPY) |
| str data2, [dst] |
| #endif |
| ret |
| 1: |
| tbz tmp1, #5, 1f |
| str data2_w, [dst], #4 |
| lsr data2, data2, #32 |
| 1: |
| tbz tmp1, #4, 1f |
| strh data2_w, [dst], #2 |
| lsr data2, data2, #16 |
| 1: |
| tbz tmp1, #3, 1f |
| strb data2_w, [dst] |
| #if defined(STPCPY) |
| ret |
| #endif |
| 1: |
| #if defined(STPCPY) |
| // Back up one so that dst points to the '\0' string terminator. |
| sub dst, dst, #1 |
| #endif |
| ret |
| |
| .Lmisaligned: |
| tbz src, #0, 1f |
| ldrb data1_w, [src], #1 |
| strb data1_w, [dst], #1 |
| cbnz data1_w, 1f |
| #if defined(STPCPY) |
| // Back up one so that dst points to the '\0' string terminator. |
| sub dst, dst, #1 |
| #endif |
| ret |
| 1: |
| tbz src, #1, 1f |
| ldrb data1_w, [src], #1 |
| strb data1_w, [dst], #1 |
| cbz data1_w, .Ldone |
| ldrb data2_w, [src], #1 |
| strb data2_w, [dst], #1 |
| cbnz data2_w, 1f |
| .Ldone: |
| #if defined(STPCPY) |
| // Back up one so that dst points to the '\0' string terminator. |
| sub dst, dst, #1 |
| #endif |
| ret |
| 1: |
| tbz src, #2, 1f |
| ldr data1_w, [src], #4 |
| // Check for a zero. |
| sub has_nul1_w, data1_w, zeroones_w |
| bic has_nul1_w, has_nul1_w, data1_w |
| ands has_nul1_w, has_nul1_w, #0x80808080 |
| b.ne .Lnul_in_data1 |
| str data1_w, [dst], #4 |
| 1: |
| tbz src, #3, .Lloop |
| ldr data1, [src], #8 |
| // Check for a zero. |
| sub tmp1, data1, zeroones |
| orr tmp2, data1, #REP8_7f |
| bics has_nul1, tmp1, tmp2 |
| b.ne .Lnul_in_data1 |
| str data1, [dst], #8 |
| b .Lloop |
| #if defined(STPCPY) |
| END(stpcpy) |
| #elif defined(STRCPY) |
| END(strcpy) |
| #endif |