Bytecode libraries are installed with `make install-bytecode'


git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@15989 91177308-0d34-0410-b5e6-96231b3b80d8
diff --git a/docs/GettingStarted.html b/docs/GettingStarted.html
index 2f78b9d..3f404dc 100644
--- a/docs/GettingStarted.html
+++ b/docs/GettingStarted.html
@@ -738,18 +738,17 @@
 
   <dt><tt>gmake distclean</tt>
   <dd>
-  Removes everything that <tt>gmake clean</tt> does, but also removes
-  files generated by <tt>configure</tt>.  It attempts to return the
-  source tree to the original state in which it was shipped.
+  Removes everything that <tt>gmake clean</tt> does, but also removes files
+  generated by <tt>configure</tt>.  It attempts to return the source tree to the
+  original state in which it was shipped.
   <p>
 
-  <dt><tt>gmake install</tt>
+  <dt><tt>gmake install-bytecode</tt>
   <dd>
-  Installs LLVM files into the proper location.  For the most part,
-  this does nothing, but it does install bytecode libraries into the
-  GCC front end's bytecode library directory.  If you need to update
-  your bytecode libraries, this is the target to use once you've built
-  them.
+  Assuming you built LLVM into $OBJDIR, when this command is run in
+  $OBJDIR/runtime, it will install bytecode libraries into the GCC front end's
+  bytecode library directory.  If you need to update your bytecode libraries,
+  this is the target to use once you've built them.
   <p>
 </dl>