target: msm8916: enable the dsi2HDMI bridge chip
Add support for programming the DSI to HDMI bridge
chip which enables the chip to convert the DSI input
to HDMI output. It enables support for the HDMI panels
over DSI interface.
Change-Id: I06c115fa85d7dbab0f9956f58f64ca9605e26594
diff --git a/target/msm8916/oem_panel.c b/target/msm8916/oem_panel.c
index 4c51fcb..0562017 100644
--- a/target/msm8916/oem_panel.c
+++ b/target/msm8916/oem_panel.c
@@ -34,6 +34,7 @@
#include <board.h>
#include <mipi_dsi.h>
#include <target/display.h>
+#include <mipi_dsi_i2c.h>
#include "include/panel.h"
#include "panel_display.h"
@@ -58,6 +59,8 @@
#include "include/panel_r61318_hd_video.h"
#include "include/panel_r63417_1080p_video.h"
#include "include/panel_jdi_a216_fhd_video.h"
+#include "include/panel_adv7533_1080p60.h"
+#include "include/panel_adv7533_720p60.h"
#define DISPLAY_MAX_PANEL_DETECTION 2
#define OTM8019A_FWVGA_VIDEO_PANEL_ON_DELAY 50
@@ -97,6 +100,8 @@
{"r61318_hd_video", R61318_HD_VIDEO_PANEL},
{"r63417_1080p_video", R63417_1080P_VIDEO_PANEL},
{"jdi_a216_fhd_video", JDI_A216_FHD_VIDEO_PANEL},
+ {"adv7533_1080p_video", ADV7533_1080P_VIDEO_PANEL},
+ {"adv7533_720p_video", ADV7533_720P_VIDEO_PANEL},
};
static uint32_t panel_id;
@@ -554,6 +559,41 @@
memcpy(phy_db->timing,
jdi_a216_fhd_video_timings, TIMING_SIZE);
break;
+ case ADV7533_1080P_VIDEO_PANEL:
+ panelstruct->paneldata = &adv7533_1080p_video_panel_data;
+ panelstruct->panelres = &adv7533_1080p_video_panel_res;
+ panelstruct->color = &adv7533_1080p_video_color;
+ panelstruct->videopanel = &adv7533_1080p_video_video_panel;
+ panelstruct->commandpanel = &adv7533_1080p_video_command_panel;
+ panelstruct->state = &adv7533_1080p_video_state;
+ panelstruct->laneconfig = &adv7533_1080p_video_lane_config;
+ panelstruct->paneltiminginfo
+ = &adv7533_1080p_video_timing_info;
+ pinfo->adv7533.dsi_tg_i2c_cmd = &adv7533_1080p_tg_i2c_command;
+ pinfo->adv7533.num_of_tg_i2c_cmds = ADV7533_1080P_TG_COMMANDS;
+ pinfo->adv7533.dsi_setup_cfg_i2c_cmd = &adv7533_1080p_common_cfg;
+ pinfo->adv7533.num_of_cfg_i2c_cmds = ADV7533_1080P_CONFIG_COMMANDS;
+ memcpy(phy_db->timing,
+ adv7533_1080p_video_timings, TIMING_SIZE);
+ break;
+
+ case ADV7533_720P_VIDEO_PANEL:
+ panelstruct->paneldata = &adv7533_720p_video_panel_data;
+ panelstruct->panelres = &adv7533_720p_video_panel_res;
+ panelstruct->color = &adv7533_720p_video_color;
+ panelstruct->videopanel = &adv7533_720p_video_video_panel;
+ panelstruct->commandpanel = &adv7533_720p_video_command_panel;
+ panelstruct->state = &adv7533_720p_video_state;
+ panelstruct->laneconfig = &adv7533_720p_video_lane_config;
+ panelstruct->paneltiminginfo
+ = &adv7533_720p_video_timing_info;
+ pinfo->adv7533.dsi_tg_i2c_cmd = &adv7533_720p_tg_i2c_command;
+ pinfo->adv7533.num_of_tg_i2c_cmds = ADV7533_720P_TG_COMMANDS;
+ pinfo->adv7533.dsi_setup_cfg_i2c_cmd = &adv7533_720p_common_cfg;
+ pinfo->adv7533.num_of_cfg_i2c_cmds = ADV7533_720P_CONFIG_COMMANDS;
+ memcpy(phy_db->timing,
+ adv7533_720p_video_timings, TIMING_SIZE);
+ break;
case UNKNOWN_PANEL:
default:
memset(panelstruct, 0, sizeof(struct panel_struct));
@@ -584,6 +624,7 @@
uint32_t hw_subtype = board_hardware_subtype();
int32_t panel_override_id;
uint32_t target_id, plat_hw_ver_major;
+ uint8_t rev = 0;
if (panel_name) {
panel_override_id = panel_name_to_id(supp_panels,
@@ -702,6 +743,22 @@
}
}
break;
+ case HW_PLATFORM_SBC:
+ if (platform_is_apq8016()) {
+ /* Set Switch GPIO to DSI2HDMI mode */
+ target_set_switch_gpio(1);
+ /* ADV7533 DSI to HDMI Bridge Chip Connected */
+ mipi_dsi_i2c_device_init();
+ /* Read ADV Chip ID */
+ if (!mipi_dsi_i2c_read_byte(ADV7533_MAIN, 0x00, &rev)) {
+ dprintf(INFO, "ADV7533 Rev ID: 0x%x\n",rev);
+ } else {
+ dprintf(CRITICAL, "error reading Rev ID from bridge chip\n");
+ return PANEL_TYPE_UNKNOWN;
+ }
+ panel_id = ADV7533_720P_VIDEO_PANEL;
+ }
+ break;
default:
dprintf(CRITICAL, "Display not enabled for %d HW type\n",
hw_id);