/* Copyright (c) 2015, The Linux Foundation. All rights reserved.
 *
 * Redistribution and use in source and binary forms, with or without
 * modification, are permitted provided that the following conditions are
 * met:
 *     * Redistributions of source code must retain the above copyright
 *       notice, this list of conditions and the following disclaimer.
 *     * Redistributions in binary form must reproduce the above
 *       copyright notice, this list of conditions and the following
 *       disclaimer in the documentation and/or other materials provided
 *       with the distribution.
 *     * Neither the name of The Linux Foundation nor the names of its
 *       contributors may be used to endorse or promote products derived
 *       from this software without specific prior written permission.
 *
 * THIS SOFTWARE IS PROVIDED "AS IS" AND ANY EXPRESS OR IMPLIED
 * WARRANTIES, INCLUDING, BUT NOT LIMITED TO, THE IMPLIED WARRANTIES OF
 * MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE AND NON-INFRINGEMENT
 * ARE DISCLAIMED.  IN NO EVENT SHALL THE COPYRIGHT OWNER OR CONTRIBUTORS
 * BE LIABLE FOR ANY DIRECT, INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY, OR
 * CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF
 * SUBSTITUTE GOODS OR SERVICES; LOSS OF USE, DATA, OR PROFITS; OR
 * BUSINESS INTERRUPTION) HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY,
 * WHETHER IN CONTRACT, STRICT LIABILITY, OR TORT (INCLUDING NEGLIGENCE
 * OR OTHERWISE) ARISING IN ANY WAY OUT OF THE USE OF THIS SOFTWARE, EVEN
 * IF ADVISED OF THE POSSIBILITY OF SUCH DAMAGE.
 */

#include <debug.h>
#include <platform/iomap.h>
#include <reg.h>
#include <target.h>
#include <platform.h>
#include <uart_dm.h>
#include <platform/gpio.h>
#include <lib/ptable.h>
#include <qpic_nand.h>
#include <dev/keys.h>
#include <spmi_v2.h>
#include <pm8x41.h>
#include <board.h>
#include <baseband.h>
#include <hsusb.h>
#include <scm.h>
#include <platform/gpio.h>
#include <platform/gpio.h>
#include <platform/irqs.h>
#include <platform/clock.h>
#include <crypto5_wrapper.h>
#include <partition_parser.h>
#include <stdlib.h>

#if LONG_PRESS_POWER_ON
#include <shutdown_detect.h>
#endif

#define FASTBOOT_MODE           0x77665500
#define PON_SOFT_RB_SPARE       0x88F

extern void smem_ptable_init(void);
extern void smem_add_modem_partitions(struct ptable *flash_ptable);

static struct ptable flash_ptable;

/* PMIC config data */
#define PMIC_ARB_CHANNEL_NUM    0
#define PMIC_ARB_OWNER_ID       0

/* NANDc BAM pipe numbers */
#define DATA_CONSUMER_PIPE      0
#define DATA_PRODUCER_PIPE      1
#define CMD_PIPE                2

/* NANDc BAM pipe groups */
#define DATA_PRODUCER_PIPE_GRP   0
#define DATA_CONSUMER_PIPE_GRP   0
#define CMD_PIPE_GRP             1

/* NANDc EE */
#define QPIC_NAND_EE      0

/* NANDc max desc length. */
#define QPIC_NAND_MAX_DESC_LEN   0x7FFF

#define LAST_NAND_PTN_LEN_PATTERN 0xFFFFFFFF
#define UBI_CMDLINE " rootfstype=ubifs rootflags=bulk_read"

struct qpic_nand_init_config config;

void update_ptable_names(void)
{
	uint32_t ptn_index;
	struct ptentry *ptentry_ptr = flash_ptable.parts;
	struct ptentry *boot_ptn;
	unsigned i;
	uint32_t len;

	/* Change all names to lower case. */
	for (ptn_index = 0; ptn_index != (uint32_t)flash_ptable.count; ptn_index++)
	{
		len = strlen(ptentry_ptr[ptn_index].name);
		for (i = 0; i < len; i++)
		{
			if (isupper(ptentry_ptr[ptn_index].name[i]))
			{
				ptentry_ptr[ptn_index].name[i] = tolower(ptentry_ptr[ptn_index].name[i]);
			}
		}
		/* SBL fills in the last partition length as 0xFFFFFFFF.
	* Update the length field based on the number of blocks on the flash.*/
		if ((uint32_t)(ptentry_ptr[ptn_index].length) == LAST_NAND_PTN_LEN_PATTERN)
		{
			ptentry_ptr[ptn_index].length = flash_num_blocks() - ptentry_ptr[ptn_index].start;
		}
	}
}

/* Return Non zero (i.e 0x2) if vol_down pressed */
uint32_t target_volume_down()
{
	/* Volume down button tied in with PMIC RESIN. */
	return pm8x41_resin_status();
}

static void target_keystatus()
{
	keys_init();

	if(target_volume_down())
		keys_post_event(KEY_VOLUMEDOWN, 1);
}

void target_early_init(void)
{
#if WITH_DEBUG_UART
	/*BLSP1 and UART5*/
	uart_dm_init(5, 0, BLSP1_UART5_BASE);
#endif
}

/* Configure PMIC and Drop PS_HOLD for shutdown */
void shutdown_device()
{
	dprintf(CRITICAL, "Going down for shutdown.\n");

	/* Configure PMIC for shutdown */
	pm8x41_reset_configure(PON_PSHOLD_SHUTDOWN);

	/* Drop PS_HOLD for MSM */
	writel(0x00, MPM2_MPM_PS_HOLD);

	mdelay(5000);

	dprintf(CRITICAL, "shutdown failed\n");

	ASSERT(0);
}


void target_init(void)
{
	uint32_t base_addr;
	uint8_t slot;

	dprintf(INFO, "target_init()\n");

	spmi_init(PMIC_ARB_CHANNEL_NUM, PMIC_ARB_OWNER_ID);

	target_keystatus();
	config.pipes.read_pipe = DATA_PRODUCER_PIPE;
	config.pipes.write_pipe = DATA_CONSUMER_PIPE;
	config.pipes.cmd_pipe = CMD_PIPE;

	config.pipes.read_pipe_grp = DATA_PRODUCER_PIPE_GRP;
	config.pipes.write_pipe_grp = DATA_CONSUMER_PIPE_GRP;
	config.pipes.cmd_pipe_grp = CMD_PIPE_GRP;

	config.bam_base = MSM_NAND_BAM_BASE;
	config.nand_base = MSM_NAND_BASE;
	config.ee = QPIC_NAND_EE;
	config.max_desc_len = QPIC_NAND_MAX_DESC_LEN;

	qpic_nand_init(&config);

	ptable_init(&flash_ptable);
	smem_ptable_init();
	smem_add_modem_partitions(&flash_ptable);

	update_ptable_names();
	flash_set_ptable(&flash_ptable);
}

/* Identify the current target */
void target_detect(struct board_data *board)
{
	/* This property is filled as part of board.c */
}

unsigned board_machtype(void)
{
}

/* Identify the baseband being used */
void target_baseband_detect(struct board_data *board)
{
	uint32_t platform = board->platform;

	switch(platform)
	{
	case MDM9607:
	case MDM8207:
	case MDM9207:
	case MDM9307:
	case MDM9628:
		board->baseband = BASEBAND_MDM;
        break;
	default:
		dprintf(CRITICAL, "Platform type: %u is not supported\n", platform);
		ASSERT(0);
	};
}

void target_serialno(unsigned char *buf)
{
	uint32_t serialno;
	serialno = board_chip_serial();
	snprintf((char *)buf, 13, "%x", serialno);
}

unsigned check_reboot_mode(void)
{
	uint32_t restart_reason = 0;

	/* Read reboot reason and scrub it */
	restart_reason = readl(RESTART_REASON_ADDR);
	writel(0x00, RESTART_REASON_ADDR);

	return restart_reason;
}

int get_target_boot_params(const char *cmdline, const char *part, char **buf)
{
	struct ptable *ptable;
	int system_ptn_index = -1;
	uint32_t buflen = strlen(UBI_CMDLINE) + strlen(" root=ubi0:rootfs ubi.mtd=") + sizeof(int) + 1; /* 1 byte for null character*/

	*buf = (char *)malloc(buflen);
	if(!(*buf)) {
		dprintf(CRITICAL,"Unable to allocate memory for boot params\n");
		return -1;
	}

	ptable = flash_get_ptable();
	if (!ptable) {
		dprintf(CRITICAL,"WARN: Cannot get flash partition table\n");
		free(*buf);
		return -1;
	}

	system_ptn_index = ptable_get_index(ptable, part);
	if (system_ptn_index < 0) {
		dprintf(CRITICAL,"WARN: Cannot get partition index for %s\n", part);
		free(*buf);
		return -1;
	}
	/* Adding command line parameters according to target boot type */
	snprintf(*buf, buflen, UBI_CMDLINE);

	/*check if cmdline contains "root=" at the beginning of buffer or
	* " root=" in the middle of buffer.
	*/
	if (((!strncmp(cmdline, "root=", strlen("root="))) ||
		(strstr(cmdline, " root="))))
		dprintf(DEBUG, "DEBUG: cmdline has root=\n");
	else
		snprintf(*buf+strlen(*buf), buflen, " root=ubi0:rootfs ubi.mtd=%d", system_ptn_index);
		/*in success case buf will be freed in the calling function of this*/
	return 0;
}

void target_usb_init(void)
{
	uint32_t val;

	/* Select and enable external configuration with USB PHY */
	ulpi_write(ULPI_MISC_A_VBUSVLDEXTSEL | ULPI_MISC_A_VBUSVLDEXT, ULPI_MISC_A_SET);

	/* Enable sess_vld */
	val = readl(USB_GENCONFIG_2) | GEN2_SESS_VLD_CTRL_EN;
	writel(val, USB_GENCONFIG_2);

	/* Enable external vbus configuration in the LINK */
	val = readl(USB_USBCMD);
	val |= SESS_VLD_CTRL;
	writel(val, USB_USBCMD);
}

void target_uninit(void)
{
}

void reboot_device(unsigned reboot_reason)
{
	uint8_t reset_type = 0;
	 /* Write the reboot reason */
	writel(reboot_reason, RESTART_REASON_ADDR);

	/* Configure PMIC for warm reset */
	/* PM 8019 v1 aligns with PM8941 v2.
	* This call should be based on the pmic version
	* when PM8019 v2 is available.
	*/
	if(reboot_reason)
		reset_type = PON_PSHOLD_WARM_RESET;
	else
		reset_type = PON_PSHOLD_HARD_RESET;

	pm8x41_v2_reset_configure(reset_type);

	/* Drop PS_HOLD for MSM */
	writel(0x00, MPM2_MPM_PS_HOLD);

	mdelay(5000);

	dprintf(CRITICAL, "Rebooting failed\n");
	return;
}