blob: 5dcaa636919b8ca035bbf4e00e0bc3269053aa03 [file] [log] [blame]
/*
* Copyright (c) 2008, Google Inc.
* All rights reserved.
* Copyright (c) 2009-2011, Code Aurora Forum. All rights reserved.
*
* Redistribution and use in source and binary forms, with or without
* modification, are permitted provided that the following conditions
* are met:
* * Redistributions of source code must retain the above copyright
* notice, this list of conditions and the following disclaimer.
* * Redistributions in binary form must reproduce the above copyright
* notice, this list of conditions and the following disclaimer in
* the documentation and/or other materials provided with the
* distribution.
* * Neither the name of Google, Inc. nor the names of its contributors
* may be used to endorse or promote products derived from this
* software without specific prior written permission.
*
* THIS SOFTWARE IS PROVIDED BY THE COPYRIGHT HOLDERS AND CONTRIBUTORS
* "AS IS" AND ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT
* LIMITED TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS
* FOR A PARTICULAR PURPOSE ARE DISCLAIMED. IN NO EVENT SHALL THE
* COPYRIGHT OWNER OR CONTRIBUTORS BE LIABLE FOR ANY DIRECT, INDIRECT,
* INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL DAMAGES (INCLUDING,
* BUT NOT LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS OR SERVICES; LOSS
* OF USE, DATA, OR PROFITS; OR BUSINESS INTERRUPTION) HOWEVER CAUSED
* AND ON ANY THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT LIABILITY,
* OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY OUT
* OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY OF
* SUCH DAMAGE.
*/
#include <debug.h>
#include <reg.h>
#include <dev/fbcon.h>
#include <kernel/thread.h>
#include <platform/debug.h>
#include <mddi_hw.h>
#include "gpio_hw.h"
#include <dev/lcdc.h>
void platform_init_interrupts(void);
void platform_init_timer();
void uart2_clock_init(void);
void uart_init(void);
struct fbcon_config *lcdc_init(void);
#define ARRAY_SIZE(a) (sizeof(a)/(sizeof((a)[0])))
static unsigned uart2_gpio_table[] = {
GPIO_CFG(49, 2, GPIO_OUTPUT, GPIO_PULL_DOWN, GPIO_2MA),
GPIO_CFG(50, 2, GPIO_INPUT, GPIO_PULL_DOWN, GPIO_2MA),
GPIO_CFG(51, 2, GPIO_INPUT, GPIO_PULL_DOWN, GPIO_2MA),
GPIO_CFG(52, 2, GPIO_OUTPUT, GPIO_PULL_DOWN, GPIO_2MA),
};
/* CRCI - mmc slot mapping.
* mmc slot numbering start from 1.
* entry at index 0 is just dummy.
*/
uint8_t sdc_crci_map[5] = {0, 6, 7, 12, 13};
void uart2_mux_init(void)
{
platform_gpios_enable(uart2_gpio_table, ARRAY_SIZE(uart2_gpio_table));
}
void platform_early_init(void)
{
#if WITH_DEBUG_UART
uart2_mux_init();
uart2_clock_init();
uart_init();
#endif
platform_init_interrupts();
platform_init_timer();
}
void platform_init(void)
{
struct fbcon_config *fb_cfg;
dprintf(INFO, "platform_init()\n");
acpu_clock_init();
adm_enable_clock();
ce_enable_clock();
}
void mdp4_display_intf_sel(int output, int intf)
{
unsigned bits, mask;
unsigned dma2_cfg_reg;
bits = readl(MSM_MDP_BASE1 + 0x0038);
mask = 0x03; /* 2 bits */
intf &= 0x03; /* 2 bits */
switch (output) {
case EXTERNAL_INTF_SEL:
intf <<= 4;
mask <<= 4;
break;
case SECONDARY_INTF_SEL:
intf &= 0x02; /* only MDDI and EBI2 support */
intf <<= 2;
mask <<= 2;
break;
default:
break;
}
bits &= ~mask;
bits |= intf;
writel(bits, MSM_MDP_BASE1 + 0x0038); /* MDP_DISP_INTF_SEL */
}
void display_init(void)
{
struct fbcon_config *fb_cfg;
#if DISPLAY_TYPE_MDDI
mddi_pmdh_clock_init();
mddi_panel_poweron();
/* We need to config GPIO 38 for Sleep clock with Spl Fun 2 */
toshiba_pmic_gpio_init(GPIO38_GPIO_CNTRL);
fb_cfg = mddi_init();
fbcon_setup(fb_cfg);
#endif
#if DISPLAY_TYPE_LCDC
struct lcdc_timing_parameters *lcd_timing;
mdp_lcdc_clock_init();
lcd_timing = get_lcd_timing();
fb_cfg = lcdc_init_set( lcd_timing );
panel_poweron();
fbcon_setup(fb_cfg);
#endif
}
void display_shutdown(void)
{
#if DISPLAY_TYPE_LCDC
/* Turning off LCDC */
lcdc_shutdown();
#endif
}
void platform_uninit(void)
{
platform_uninit_timer();
#if DISPLAY_SPLASH_SCREEN
display_shutdown();
#endif
}