Blackfin EMAC driver: fix bug - NAT doesn't work with bfin_mac driver
https://blackfin.uclinux.org/gf/project/uclinux-dist/forum/?action=ForumBrowse&forum_id=39&thread_id=23114&_forum_action=ForumMessageBrowse
Today I was dealing with the same problem, on my custom bf537 board, and bfin_mac driver.
I found that the problem is in setting ip_summed flag of skbuff structure,
Signed-off-by: Vitja Makarov <vitja.makarov@gmail.com>
Signed-off-by: Sonic Zhang <sonic.zhang@analog.com>
Signed-off-by: Bryan Wu <bryan.wu@analog.com>
Signed-off-by: Jeff Garzik <jeff@garzik.org>
diff --git a/drivers/net/bfin_mac.c b/drivers/net/bfin_mac.c
index 084acfd..f0f8516 100644
--- a/drivers/net/bfin_mac.c
+++ b/drivers/net/bfin_mac.c
@@ -676,7 +676,7 @@
skb->protocol = eth_type_trans(skb, dev);
#if defined(BFIN_MAC_CSUM_OFFLOAD)
skb->csum = current_rx_ptr->status.ip_payload_csum;
- skb->ip_summed = CHECKSUM_PARTIAL;
+ skb->ip_summed = CHECKSUM_COMPLETE;
#endif
netif_rx(skb);