ocfs2: Create locks at initially requested level
If we have not yet created a cluster lock, ocfs2_cluster_lock() will
first create it at NLMODE, and then convert the lock to either PRMODE or
EXMODE (whichever is requested).
Change ocfs2_cluster_lock() to just create the lock at the initially
requested level. ocfs2_locking_ast() handles this case fine, so the only
update required was in setup of locking state. This should reduce the number
of network messages required for a new lock by one, providing an incremental
performance enhancement.
Signed-off-by: Mark Fasheh <mark.fasheh@oracle.com>
diff --git a/fs/ocfs2/dlmglue.c b/fs/ocfs2/dlmglue.c
index ef09fd2..4e97dcc 100644
--- a/fs/ocfs2/dlmglue.c
+++ b/fs/ocfs2/dlmglue.c
@@ -980,18 +980,6 @@
goto unlock;
}
- if (!(lockres->l_flags & OCFS2_LOCK_ATTACHED)) {
- /* lock has not been created yet. */
- spin_unlock_irqrestore(&lockres->l_lock, flags);
-
- ret = ocfs2_lock_create(osb, lockres, LKM_NLMODE, 0);
- if (ret < 0) {
- mlog_errno(ret);
- goto out;
- }
- goto again;
- }
-
if (lockres->l_flags & OCFS2_LOCK_BLOCKED &&
!ocfs2_may_continue_on_blocked_lock(lockres, level)) {
/* is the lock is currently blocked on behalf of
@@ -1006,7 +994,14 @@
mlog(ML_ERROR, "lockres %s has action %u pending\n",
lockres->l_name, lockres->l_action);
- lockres->l_action = OCFS2_AST_CONVERT;
+ if (!(lockres->l_flags & OCFS2_LOCK_ATTACHED)) {
+ lockres->l_action = OCFS2_AST_ATTACH;
+ lkm_flags &= ~LKM_CONVERT;
+ } else {
+ lockres->l_action = OCFS2_AST_CONVERT;
+ lkm_flags |= LKM_CONVERT;
+ }
+
lockres->l_requested = level;
lockres_or_flags(lockres, OCFS2_LOCK_BUSY);
spin_unlock_irqrestore(&lockres->l_lock, flags);
@@ -1021,7 +1016,7 @@
status = dlmlock(osb->dlm,
level,
&lockres->l_lksb,
- lkm_flags|LKM_CONVERT,
+ lkm_flags,
lockres->l_name,
OCFS2_LOCK_ID_MAX_LEN - 1,
ocfs2_locking_ast,