| /******************************************************************************* |
| |
| Header file for stmmac platform data |
| |
| Copyright (C) 2009 STMicroelectronics Ltd |
| |
| This program is free software; you can redistribute it and/or modify it |
| under the terms and conditions of the GNU General Public License, |
| version 2, as published by the Free Software Foundation. |
| |
| This program is distributed in the hope it will be useful, but WITHOUT |
| ANY WARRANTY; without even the implied warranty of MERCHANTABILITY or |
| FITNESS FOR A PARTICULAR PURPOSE. See the GNU General Public License for |
| more details. |
| |
| You should have received a copy of the GNU General Public License along with |
| this program; if not, write to the Free Software Foundation, Inc., |
| 51 Franklin St - Fifth Floor, Boston, MA 02110-1301 USA. |
| |
| The full GNU General Public License is included in this distribution in |
| the file called "COPYING". |
| |
| Author: Giuseppe Cavallaro <peppe.cavallaro@st.com> |
| *******************************************************************************/ |
| |
| #ifndef __STMMAC_PLATFORM_DATA |
| #define __STMMAC_PLATFORM_DATA |
| |
| #include <linux/platform_device.h> |
| |
| #define STMMAC_RX_COE_NONE 0 |
| #define STMMAC_RX_COE_TYPE1 1 |
| #define STMMAC_RX_COE_TYPE2 2 |
| |
| /* Define the macros for CSR clock range parameters to be passed by |
| * platform code. |
| * This could also be configured at run time using CPU freq framework. */ |
| |
| /* MDC Clock Selection define*/ |
| #define STMMAC_CSR_60_100M 0x0 /* MDC = clk_scr_i/42 */ |
| #define STMMAC_CSR_100_150M 0x1 /* MDC = clk_scr_i/62 */ |
| #define STMMAC_CSR_20_35M 0x2 /* MDC = clk_scr_i/16 */ |
| #define STMMAC_CSR_35_60M 0x3 /* MDC = clk_scr_i/26 */ |
| #define STMMAC_CSR_150_250M 0x4 /* MDC = clk_scr_i/102 */ |
| #define STMMAC_CSR_250_300M 0x5 /* MDC = clk_scr_i/122 */ |
| |
| /* The MDC clock could be set higher than the IEEE 802.3 |
| * specified frequency limit 0f 2.5 MHz, by programming a clock divider |
| * of value different than the above defined values. The resultant MDIO |
| * clock frequency of 12.5 MHz is applicable for the interfacing chips |
| * supporting higher MDC clocks. |
| * The MDC clock selection macros need to be defined for MDC clock rate |
| * of 12.5 MHz, corresponding to the following selection. |
| */ |
| #define STMMAC_CSR_I_4 0x8 /* clk_csr_i/4 */ |
| #define STMMAC_CSR_I_6 0x9 /* clk_csr_i/6 */ |
| #define STMMAC_CSR_I_8 0xA /* clk_csr_i/8 */ |
| #define STMMAC_CSR_I_10 0xB /* clk_csr_i/10 */ |
| #define STMMAC_CSR_I_12 0xC /* clk_csr_i/12 */ |
| #define STMMAC_CSR_I_14 0xD /* clk_csr_i/14 */ |
| #define STMMAC_CSR_I_16 0xE /* clk_csr_i/16 */ |
| #define STMMAC_CSR_I_18 0xF /* clk_csr_i/18 */ |
| |
| /* AXI DMA Burst length supported */ |
| #define DMA_AXI_BLEN_4 (1 << 1) |
| #define DMA_AXI_BLEN_8 (1 << 2) |
| #define DMA_AXI_BLEN_16 (1 << 3) |
| #define DMA_AXI_BLEN_32 (1 << 4) |
| #define DMA_AXI_BLEN_64 (1 << 5) |
| #define DMA_AXI_BLEN_128 (1 << 6) |
| #define DMA_AXI_BLEN_256 (1 << 7) |
| #define DMA_AXI_BLEN_ALL (DMA_AXI_BLEN_4 | DMA_AXI_BLEN_8 | DMA_AXI_BLEN_16 \ |
| | DMA_AXI_BLEN_32 | DMA_AXI_BLEN_64 \ |
| | DMA_AXI_BLEN_128 | DMA_AXI_BLEN_256) |
| |
| /* Platfrom data for platform device structure's platform_data field */ |
| |
| struct stmmac_mdio_bus_data { |
| int (*phy_reset)(void *priv); |
| unsigned int phy_mask; |
| int *irqs; |
| int probed_phy_irq; |
| #ifdef CONFIG_OF |
| int reset_gpio, active_low; |
| u32 delays[3]; |
| #endif |
| }; |
| |
| struct stmmac_dma_cfg { |
| int pbl; |
| int fixed_burst; |
| int mixed_burst; |
| int burst_len; |
| }; |
| |
| struct plat_stmmacenet_data { |
| char *phy_bus_name; |
| int bus_id; |
| int phy_addr; |
| int interface; |
| struct stmmac_mdio_bus_data *mdio_bus_data; |
| struct stmmac_dma_cfg *dma_cfg; |
| int clk_csr; |
| int has_gmac; |
| int enh_desc; |
| int tx_coe; |
| int rx_coe; |
| int bugged_jumbo; |
| int pmt; |
| int force_sf_dma_mode; |
| int force_thresh_dma_mode; |
| int riwt_off; |
| int max_speed; |
| void (*fix_mac_speed)(void *priv, unsigned int speed); |
| void (*bus_setup)(void __iomem *ioaddr); |
| void *(*setup)(struct platform_device *pdev); |
| void (*free)(struct platform_device *pdev, void *priv); |
| int (*init)(struct platform_device *pdev, void *priv); |
| void (*exit)(struct platform_device *pdev, void *priv); |
| void *custom_cfg; |
| void *custom_data; |
| void *bsp_priv; |
| }; |
| |
| /* of_data for SoC glue layer device tree bindings */ |
| |
| struct stmmac_of_data { |
| int has_gmac; |
| int enh_desc; |
| int tx_coe; |
| int rx_coe; |
| int bugged_jumbo; |
| int pmt; |
| int riwt_off; |
| void (*fix_mac_speed)(void *priv, unsigned int speed); |
| void (*bus_setup)(void __iomem *ioaddr); |
| void *(*setup)(struct platform_device *pdev); |
| void (*free)(struct platform_device *pdev, void *priv); |
| int (*init)(struct platform_device *pdev, void *priv); |
| void (*exit)(struct platform_device *pdev, void *priv); |
| }; |
| #endif |