usb: chipidea: move hw_phymode_configure() into probe
Currently hw_phymode_configure() is located inside hw_device_reset(), which is
only called by chipidea udc driver.
When operating in host mode, we also need to call hw_phymode_configure() in
order to properly configure the PHY mode, so move this function into probe.
After this change, USB Host1 port on mx53qsb board is functional.
Signed-off-by: Fabio Estevam <fabio.estevam@freescale.com>
Tested-by: Arnaud Patard <arnaud.patard@rtp-net.org>
Reviewed-by: Peter Chen <peter.chen@freescale.com>
Signed-off-by: Alexander Shishkin <alexander.shishkin@linux.intel.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
diff --git a/drivers/usb/chipidea/core.c b/drivers/usb/chipidea/core.c
index a5df24c..a5b3774 100644
--- a/drivers/usb/chipidea/core.c
+++ b/drivers/usb/chipidea/core.c
@@ -264,8 +264,6 @@
while (hw_read(ci, OP_USBCMD, USBCMD_RST))
udelay(10); /* not RTOS friendly */
- hw_phymode_configure(ci);
-
if (ci->platdata->notify_event)
ci->platdata->notify_event(ci,
CI_HDRC_CONTROLLER_RESET_EVENT);
@@ -457,6 +455,8 @@
if (!ci->platdata->phy_mode)
ci->platdata->phy_mode = of_usb_get_phy_mode(dev->of_node);
+ hw_phymode_configure(ci);
+
if (!ci->platdata->dr_mode)
ci->platdata->dr_mode = of_usb_get_dr_mode(dev->of_node);