V4L/DVB (5458): Tda1004x: add ts_mode option to config struct
The struct tda1004x_config has a new entry: .ts_mode
Possible values are TDA10046_TS_PARALLEL or TDA10046_TS_SERIAL
There always is only one interface active, default is parallel.
Signed-off-by: Hartmut Hackmann <hartmut.hackmann@t-online.de>
Signed-off-by: Michael Krufky <mkrufky@linuxtv.org>
Signed-off-by: Mauro Carvalho Chehab <mchehab@infradead.org>
diff --git a/drivers/media/dvb/frontends/tda1004x.h b/drivers/media/dvb/frontends/tda1004x.h
index 6badc81..abae843 100644
--- a/drivers/media/dvb/frontends/tda1004x.h
+++ b/drivers/media/dvb/frontends/tda1004x.h
@@ -61,6 +61,11 @@
TDA10046_FREQ_052, /* low IF, 5.1667 MHZ for tda9889 */
};
+enum tda10046_tsout {
+ TDA10046_TS_PARALLEL = 0x00, /* parallel transport stream, default */
+ TDA10046_TS_SERIAL = 0x01, /* serial transport stream */
+};
+
struct tda1004x_config
{
/* the demodulator's i2c address */
@@ -72,6 +77,9 @@
/* Does the OCLK signal need inverted? */
u8 invert_oclk;
+ /* parallel or serial transport stream */
+ enum tda10046_tsout ts_mode;
+
/* Xtal frequency, 4 or 16MHz*/
enum tda10046_xtal xtal_freq;