[POWERPC] pseries: Remove dead EEH video code
Remove dead code, and a misleading comment about EEH checking
for video devices. The removed code is a left-over from the
olden days where there was concern over how video devices
worked in Linux. We are never going to go that way again,
so kill this.
Signed-off-by: Linas Vepstas <linas@austin.ibm.com>
----
arch/powerpc/platforms/pseries/eeh.c | 17 -----------------
1 file changed, 17 deletions(-)
Signed-off-by: Paul Mackerras <paulus@samba.org>
diff --git a/arch/powerpc/platforms/pseries/eeh.c b/arch/powerpc/platforms/pseries/eeh.c
index 41b64b3..b242c6c 100644
--- a/arch/powerpc/platforms/pseries/eeh.c
+++ b/arch/powerpc/platforms/pseries/eeh.c
@@ -969,23 +969,6 @@
}
pdn->class_code = *class_code;
- /*
- * Now decide if we are going to "Disable" EEH checking
- * for this device. We still run with the EEH hardware active,
- * but we won't be checking for ff's. This means a driver
- * could return bad data (very bad!), an interrupt handler could
- * hang waiting on status bits that won't change, etc.
- * But there are a few cases like display devices that make sense.
- */
- enable = 1; /* i.e. we will do checking */
-#if 0
- if ((*class_code >> 16) == PCI_BASE_CLASS_DISPLAY)
- enable = 0;
-#endif
-
- if (!enable)
- pdn->eeh_mode |= EEH_MODE_NOCHECK;
-
/* Ok... see if this device supports EEH. Some do, some don't,
* and the only way to find out is to check each and every one. */
regs = of_get_property(dn, "reg", NULL);