mmc: sdhci: only set 200mA support for 1.8v if 200mA is available
max_current_caps can return 0 if not available from the sd controller.
If no regulator is present or the regulator specifies a current
less then 200ma, we no longer still set the 200mA caps bit anyway.
Signed-off-by: Philip Rakity <prakity@marvell.com>
Reviewed-by: Aaron Lu <aaron_lu@amd.com>
Signed-off-by: Chris Ball <cjb@laptop.org>
diff --git a/drivers/mmc/core/sd.c b/drivers/mmc/core/sd.c
index b2b43f6..b0b9e37 100644
--- a/drivers/mmc/core/sd.c
+++ b/drivers/mmc/core/sd.c
@@ -553,13 +553,13 @@
static int sd_set_current_limit(struct mmc_card *card, u8 *status)
{
- int current_limit = 0;
+ int current_limit = SD_SET_CURRENT_NO_CHANGE;
int err;
/*
* Current limit switch is only defined for SDR50, SDR104, and DDR50
- * bus speed modes. For other bus speed modes, we set the default
- * current limit of 200mA.
+ * bus speed modes. For other bus speed modes, we do not change the
+ * current limit.
*/
if ((card->sd_bus_speed == UHS_SDR50_BUS_SPEED) ||
(card->sd_bus_speed == UHS_SDR104_BUS_SPEED) ||
@@ -595,17 +595,18 @@
if (card->sw_caps.sd3_curr_limit & SD_MAX_CURRENT_200)
current_limit = SD_SET_CURRENT_LIMIT_200;
}
- } else
- current_limit = SD_SET_CURRENT_LIMIT_200;
+ }
- err = mmc_sd_switch(card, 1, 3, current_limit, status);
- if (err)
- return err;
+ if (current_limit != SD_SET_CURRENT_NO_CHANGE) {
+ err = mmc_sd_switch(card, 1, 3, current_limit, status);
+ if (err)
+ return err;
- if (((status[15] >> 4) & 0x0F) != current_limit)
- pr_warning("%s: Problem setting current limit!\n",
- mmc_hostname(card->host));
+ if (((status[15] >> 4) & 0x0F) != current_limit)
+ pr_warning("%s: Problem setting current limit!\n",
+ mmc_hostname(card->host));
+ }
return 0;
}