net: ethernet: octeon: use phy_ethtool_{get|set}_link_ksettings
There are two generics functions phy_ethtool_{get|set}_link_ksettings,
so we can use them instead of defining the same code in the driver.
There was a check on CAP_NET_ADMIN in cvm_oct_set_settings, but this
check is already done in dev_ethtool, so no need to repeat it before
calling the generic function.
Signed-off-by: Philippe Reynes <tremyfr@gmail.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/staging/octeon/ethernet-mdio.c b/drivers/staging/octeon/ethernet-mdio.c
index 661b97b..1fde9c8 100644
--- a/drivers/staging/octeon/ethernet-mdio.c
+++ b/drivers/staging/octeon/ethernet-mdio.c
@@ -34,25 +34,6 @@
strlcpy(info->bus_info, "Builtin", sizeof(info->bus_info));
}
-static int cvm_oct_get_settings(struct net_device *dev, struct ethtool_cmd *cmd)
-{
- if (dev->phydev)
- return phy_ethtool_gset(dev->phydev, cmd);
-
- return -EINVAL;
-}
-
-static int cvm_oct_set_settings(struct net_device *dev, struct ethtool_cmd *cmd)
-{
- if (!capable(CAP_NET_ADMIN))
- return -EPERM;
-
- if (dev->phydev)
- return phy_ethtool_sset(dev->phydev, cmd);
-
- return -EINVAL;
-}
-
static int cvm_oct_nway_reset(struct net_device *dev)
{
if (!capable(CAP_NET_ADMIN))
@@ -66,10 +47,10 @@
const struct ethtool_ops cvm_oct_ethtool_ops = {
.get_drvinfo = cvm_oct_get_drvinfo,
- .get_settings = cvm_oct_get_settings,
- .set_settings = cvm_oct_set_settings,
.nway_reset = cvm_oct_nway_reset,
.get_link = ethtool_op_get_link,
+ .get_link_ksettings = phy_ethtool_get_link_ksettings,
+ .set_link_ksettings = phy_ethtool_set_link_ksettings,
};
/**