drivers:misc:ti-st: platform hooks for chip states
Certain platform specific or Host-WiLink Interface specific actions would be
required to be taken when the chip is being enabled and after the chip is
disabled such as configuration of the mux modes for the GPIO of host connected
to the nshutdown of the chip or relinquishing UART after the chip is disabled.
Similar actions can also be taken when the chip is in deep sleep or when the
chip is awake. Performance enhancements such as configuring the host to run
faster when chip is awake and slower when chip is asleep can also be made
here.
Signed-off-by: Pavan Savoy <pavan_savoy@ti.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>
diff --git a/drivers/misc/ti-st/st_kim.c b/drivers/misc/ti-st/st_kim.c
index 38fd2f0..6884dd1 100644
--- a/drivers/misc/ti-st/st_kim.c
+++ b/drivers/misc/ti-st/st_kim.c
@@ -434,11 +434,17 @@
{
long err = 0;
long retry = POR_RETRY_COUNT;
+ struct ti_st_plat_data *pdata;
struct kim_data_s *kim_gdata = (struct kim_data_s *)kim_data;
pr_info(" %s", __func__);
+ pdata = kim_gdata->kim_pdev->dev.platform_data;
do {
+ /* platform specific enabling code here */
+ if (pdata->chip_enable)
+ pdata->chip_enable(kim_gdata);
+
/* Configure BT nShutdown to HIGH state */
gpio_set_value(kim_gdata->nshutdown, GPIO_LOW);
mdelay(5); /* FIXME: a proper toggle */
@@ -489,6 +495,8 @@
{
long err = 0;
struct kim_data_s *kim_gdata = (struct kim_data_s *)kim_data;
+ struct ti_st_plat_data *pdata =
+ kim_gdata->kim_pdev->dev.platform_data;
INIT_COMPLETION(kim_gdata->ldisc_installed);
@@ -515,6 +523,10 @@
gpio_set_value(kim_gdata->nshutdown, GPIO_HIGH);
mdelay(1);
gpio_set_value(kim_gdata->nshutdown, GPIO_LOW);
+
+ /* platform specific disable */
+ if (pdata->chip_disable)
+ pdata->chip_disable(kim_gdata);
return err;
}